lc01707plf Sanyo Semiconductor Corporation, lc01707plf Datasheet - Page 9
![no-image](/images/manufacturer_photos/0/5/586/sanyo_semiconductor_corporation_sml.jpg)
lc01707plf
Manufacturer Part Number
lc01707plf
Description
Fm Multiple Tuner Ic
Manufacturer
Sanyo Semiconductor Corporation
Datasheet
1.LC01707PLF.pdf
(18 pages)
Communication specification
Communication specifications are indicated as below:
Serial Interface (I
Terms used in I
[Start] and [Stop] conditions
Data transmission
Sending and receiving data through I
line (SCL). This bus enables 8-bit bi-directional serial data to transmit at the maximum speed of 400kbits (fast mode).
This is not compatible with Hs mode.
The following terms are used in I
[Start] condition is required at the start of data communication and [Stop] condition at the end of data communication.
The condition in which the SDA line changes from [H] to [L] with SCL at [H] is called the [Start] condition. The
condition in which the SDA line changes from [L] to [H] with SCL at [H] is called the [Start] condition.
The length of each byte which is output to SDA line is always 8 bits. An acknowledge bit is needed after each byte.
Data is transmitted sequentially from the most significant bit (MSB).
During the data transfer, the slave address is transmitted after the [Start] condition (S).
Data transfer is always ended by the [Stop] condition (P) generated by the master.
SDA
SCL
SDA
START or repeated
START condition
SCL
Transmitter
Receiver
Master
Terms
Slave
Sr
or
S
ACK:acknowledgement
2
C
2
C-bus);
START condition
MSB
D7
1
S
Device to send data to the bus
Device to receive from the bus
Device to start data transmission, generate signal, and terminate data transmission
Device of which address is designated master
D6
2
2
C
2
C-bus that consists of two bus lines of a serial data line (SDA) and a serial clock
D1
7
D0
8
Byte complate,
interrupt within slave
ACK signal from slave
LC01707PLF
Clock pulse for ACK
9
Description
Clock line held low while
interrrupts are serviced
1
2
Clock pulse for ACK
3-8
STOP condition
ACK signal from receiver
P
9
STOP or repeated
START condition
Sr
Sr
or
P
P
SDA
SCL
No.A1928-9/18