ak4640 ETC-unknow, ak4640 Datasheet - Page 62
![no-image](/images/no-image-200.jpg)
ak4640
Manufacturer Part Number
ak4640
Description
16bit Codec With /hp/spk-ampl
Manufacturer
ETC-unknow
Datasheet
1.AK4640.pdf
(76 pages)
- Current page: 62 of 76
- Download datasheet (634Kb)
ASAHI KASEI
[AK4640]
1. Grounding and Power Supply Decoupling
The AK4640 requires careful attention to power supply and grounding arrangements. AVDD, DVDD, PVDD and HVDD
are usually supplied from the system’s analog supply. If AVDD, DVDD, PVDD and HVDD are supplied separately, the
correct power up sequence should be observed. AVSS, DVSS, PVSS and HVSS of the AK4640 should be connected to
the analog ground plane. System analog ground and digital ground should be connected together near to where the
supplies are brought onto the printed circuit board. Decoupling capacitors should be as near to the AK4640 as possible,
with the small value ceramic capacitor being the nearest.
2. Voltage Reference
VCOM is a signal ground of this chip. A 2.2µF electrolytic capacitor in parallel with a 0.1µF ceramic capacitor attached
to the VCOM pin eliminates the effects of high frequency noise. No load current may be drawn from the VCOM pin. All
signals, especially clocks, should be kept away from the VREF and VCOM pins in order to avoid unwanted coupling into
the AK4640.
3. Analog Inputs
The Mic and Beep inputs are single-ended. The input signal range scales with nominally at 0.06 x AVDD Vpp for the Mic
input and 0.6 x AVDD Vpp for the Beep input, centered around the internal common voltage (approx. 0.45 x AVDD).
Usually the input signal is AC coupled using a capacitor. The cut-off frequency is fc = (1/2πRC). The AK4640 can accept
input voltages from AVSS to AVDD.
4. Analog Outputs
The input data format for the DAC is 2’s complement. The output voltage is a positive full scale for 7FFFH(@16bit) and
a negative full scale for 8000H(@16bit). Mono output from the MOUT2 pin and Mono Line Output from the MOUT+
and MOUT− pins are centered at 0.45 x AVDD. The Headphone-Amp and Speaker-Amp outputs are centered at
HVDD/2.
MS0273-E-00
2004/03
- 62 -
Related parts for ak4640
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![AA05B-005L-120D](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
ETC-unknow
Datasheet:
![HM3-65787H-5](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
ETC-unknow
Datasheet: