wjce6354sl9g6882208 ETC-unknow, wjce6354sl9g6882208 Datasheet - Page 2

• Manufacturer Part Number: wjce6354sl9g6882208
• Description: Diversity Enabled Nordig Unified Dvb-t Cofdm Terrestrial Demodulator For Pc-tv And Hand-held Digital Tv Dtv
• Manufacturer: ETC-unknow

Applications
•
•
•
•
•
Description
The CE6354 is a superior fourth generation fully compliant ETSI ETS300 744 COFDM demodulator that exceeds,
with margin, the performance requirements of all known DVB-T digital terrestrial television standards, including
Unified Nordig and DTG.
A high performance 10 bit on-chip ADC is used to sample the 44 or 36 MHz IF analog signal. Advanced digital
filtering of the upper and lower channel enables a single 8 MHz channel SAW filter to be used for 6, 7 and 8 MHz
OFDM signal reception. All sampling and other internal clocks are derived from a single 20.48 MHz crystal or a 4
MHz clock input, the tolerance of which may be relaxed as much as 200 ppm.
The pinout of the CE6354 is highly adaptable to allow multiple devices to be connected as a diversity receiver. Any
number of CE6354s can be connected together using the high-speed five-bit diversity data bus in a chain of
devices.
Together with separate aerials and tuners for each device, the combined performance of the connected
demodulators will normally exceed a single device, especially in mobile applications or in areas where the signal is
prone to echoes and/or fading.
The CE6354 has a wide frequency capture range able to automatically compensate for the combined offset
introduced by the tuner xtal and broadcaster triple frequency offsets.
An on-chip state machine controls all acquisition and tracking operations of the CE6354 as well as controlling the
tuner via a 2-wire bus. Any frequency range can be automatically scanned for digital TV channels. This mechanism
ensures minimal interaction, maximum flexibility and fast acquisition - very low software overhead.
Also included in the design is a 7-bit ADC to detect the RF signal strength and thereby efficiently control the tuner
RF AGC.
Users have access to all the relevant signal quality information, including input signal power level, signal-to-noise
ratio, pre-Viterbi BER, post-Viterbi BER, and the uncorrectable block counts. The error rate monitoring periods are
programmable over a wide range.
The device is packaged in a 7 x 7 mm 64-pin LQFP and is very low power.
Digital terrestrial set-top boxes
Integrated digital televisions
Personal video recorders
PC-TV receivers
Portable applications
Intel Corporation
CE6354
2
Data Sheet