FM24CL04_05 RAMTRON [Ramtron International Corporation], FM24CL04_05 Datasheet - Page 5
![no-image](/images/no-image-200.jpg)
FM24CL04_05
Manufacturer Part Number
FM24CL04_05
Description
4Kb FRAM Serial Memory
Manufacturer
RAMTRON [Ramtron International Corporation]
Datasheet
1.FM24CL04_05.pdf
(11 pages)
No word address occurs for a read operation. Reads
always use the lower 8-bits that are held internally in
the address latch and the 9
slave address. Reads always begin at the address
following the previous access. A random read address
can be loaded by doing a write operation as explained
below.
After transmission of each data byte, just prior to the
acknowledge, the FM24CL04 increments the internal
address latch. This allows the next sequential byte to
be accessed with no additional addressing. After the
last address (1FFh) is reached, the address latch will
roll over to 000h. There is no limit to the number of
bytes that can be accessed with a single read or write
operation.
Data Transfer
After all address information has been transmitted,
data transfer between the bus master and the
FM24CL04 can begin. For a read operation the
FM24CL04 will place 8 data bits on the bus then wait
for an acknowledge. If the acknowledge occurs, the
next sequential byte will be transferred. If the
acknowledge is not sent, the read operation is
concluded. For a write operation, the FM24CL04 will
accept 8 data bits from the master then send an
acknowledge. All data transfer occurs MSB (most
significant bit) first.
Rev. 3.0
March 2005
Figure 4. Slave Address
th
address bit is part of the
Memory Operation
The FM24CL04 is designed to operate in a manner
very similar to other 2-wire interface memory
products. The major differences result from the
higher performance write capability of FRAM
technology. These improvements result in some
differences between the FM24CL04 and a similar
configuration EEPROM during writes. The complete
operation for both writes and reads is explained
below.
Write Operation
All writes begin with a slave address then a word
address. The bus master indicates a write operation
by setting the LSB of the Slave address to a 0. After
addressing, the bus master sends each byte of data to
the memory and the memory generates an
acknowledge condition. Any number of sequential
bytes may be written. If the end of the address range
is reached internally, the address counter will wrap
from 1FFh to 000h.
Unlike other nonvolatile memory technologies, there
is no write delay with FRAM. The entire memory
cycle occurs in less time than a single bus clock.
Therefore any operation including read or write can
occur immediately following a write. Acknowledge
polling, a technique used with EEPROMs to
determine if a write is complete is unnecessary and
will always return a done condition.
An actual memory array write occurs after the 8
data bit is transferred. It will be complete before the
acknowledge is sent. Therefore if the user desires to
abort a write without altering the memory contents,
this should be done using a start or stop condition
prior to the 8
page buffering.
Pulling write protect high will disable writes to the
entire array. The FM24CL04 will not acknowledge
data bytes that are written when write protect is
asserted. In addition, the address counter will not
increment if writes are attempted. Pulling WP low
(V
Figure 5 below illustrates both a single- and
multiple- byte write.
SS
) will deactivate this feature.
th
data bit. The FM24CL04 needs no
FM24CL04
Page 5 of 11
th