ST7-STICK45 STMICROELECTRONICS [STMicroelectronics], ST7-STICK45 Datasheet - Page 81

• Manufacturer Part Number: ST7-STICK45
• Description: 8-bit microcontroller with single voltage Flash memory, data EEPROM, ADC, timers, SPI
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

13 ELECTRICAL CHARACTERISTICS
13.1 PARAMETER CONDITIONS
Unless otherwise specified, all voltages are re-
ferred to V
13.1.1 Minimum and Maximum values
Unless otherwise specified the minimum and max-
imum values are guaranteed in the worst condi-
tions of ambient temperature, supply voltage and
frequencies by tests in production on 100% of the
devices with an ambient temperature at T
and T
range).
Data based on characterization results, design
simulation and/or technology characteristics are
indicated in the table footnotes and are not tested
in production. Based on characterization, the min-
imum and maximum values refer to sample tests
and represent the mean value plus or minus three
times the standard deviation (mean±3Σ).
13.1.2 Typical values
Unless otherwise specified, typical data are based
on T
voltage range), V
voltage
2.4V≤V
as design guidelines and are not tested.
13.1.3 Typical curves
Unless otherwise specified, all typical curves are
given only as design guidelines and are not tested.
13.1.4 Loading capacitor
The loading conditions used for pin parameter
measurement are shown in
Figure 46. Pin loading conditions
A
A
=25°C, V
=T
DD
A
≤3V voltage range). They are given only
range)
SS
max (given by the selected temperature
.
C
L
DD
DD
=5V (for the 4.5V≤V
and
=3.3V (for the 3V≤V
V
Figure
DD
=2.7V
ST7 PIN
46.
(for
DD
DD
A
=25°C
≤5.5V
≤3.6V
the
13.1.5 Pin input voltage
The input voltage measurement on a pin of the de-
vice is described in
Figure 47. Pin input voltage
ST7LITE0xY0, ST7LITESxY0
V
Figure
IN
47.
ST7 PIN
81/124
1