acpm-5007 Avago Technologies, acpm-5007 Datasheet - Page 10

• Manufacturer Part Number: acpm-5007
• Description: Lte Band7 2500-2570 Mhz 3 X 3 Mm Power Amplii Er Module
• Manufacturer: Avago Technologies

Handling and Storage
ESD (Electrostatic Discharge)
Electrostatic discharge occurs naturally in the environ-
ment. With the increase in voltage potential, the outlet of
neutralization or discharge will be sought. If the acquired
discharge route is through a semiconductor device, de-
structive damage will result.
ESD countermeasure methods should be developed and
used to control potential ESD damage during handling in
a factory environment at each manufacturing site.
MSL (Moisture Sensitivity Level)
Plastic encapsulated surface mount package is sensitive to
damage induced by absorbed moisture and temperature.
Avago Technologies follows JEDEC Standard J-STD 020B.
Each component and package type is classifi ed for
moisture sensitivity by soaking a known dry package at
Moisture Classifi cation Level and Floor Life
Note:
1. The MSL Level is marked on the MSL Label on each shipping bag.
10
MSL Level
1
2
2a
3
4
5
5a
6
Floor Life (out of bag) at factory ambient = < 30° C/60% RH or as stated
Unlimited at = < 30° C/85% RH
1 year
4 weeks
168 hours
72 hours
48 hours
24 hours
Mandatory bake before use. After bake, must be refl owed within the time limit specifi ed on the label
various temperatures and relative humidity, and times.
After soak, the components are subjected to three con-
secutive simulated refl ows.
The out of bag exposure time maximum limits are deter-
mined by the classifi cation test describe below which cor-
responds to a MSL classifi cation level 6 to 1 according to the
JEDEC standard IPC/JEDEC J-STD-020B and J-STD-033.
ACPM-5007 is MSL3. Thus, according to the J-STD-033
p.11 the maximum Manufacturers Exposure Time (MET)
for this part is 168 hours. After this time period, the part
would need to be removed from the reel, de-taped and
then re-baked. MSL classifi cation refl ow temperature for
the ACPM-5007 is targeted at 260° C +0/-5° C. Figure and
table on next page show typical SMT profi le for maximum
temperature of 260 +0/-5° C.