LTC3789 LINER [Linear Technology], LTC3789 Datasheet - Page 26

• Manufacturer Part Number: LTC3789
• Description: High Voltage High Current Controller for Battery Charging and Power Management
• Manufacturer: LINER [Linear Technology]

LTC4000
applicaTions inForMaTion
If the regulator response is under damped with the initial
large value of C
larger values of C
the over damped starting condition for further iteration.
The optimum values for R
smallest value for C
still guarantee well damped response, and which result in
the largest loop bandwidth and hence loop settling that is
as rapid as possible. The reason for this approach is that
it minimizes the variations in output voltage caused by
input ripple voltage and output load transients.
A switching regulator which is grossly over damped will
never oscillate, but it may have unacceptably large output
transients following sudden changes in input voltage or
output loading. It may also suffer from excessive overshoot
26
Figure 13. Typical Output Transient Response at Various
Stability Level
C
, R
C
C
are tried. This will normally bring about
should be increased immediately before
C
and the largest value for R
C
and C
C
normally means the
GENERATOR OUTPUT
REGULATOR OUTPUT
WITH LARGE C
WITH REDUCED C
EFFECT OF INCREASED R
FURTHER REDUCTION IN C
MAY BE POSSIBLE
IMPROPER VALUES WILL
CAUSE OSCILLATIONS
C
, SMALL R
C
C
, SMALL R
which
C
4000 F13
C
C
C
problems on startup or short circuit recovery. To guarantee
acceptable loop stability under all conditions, the initial
values chosen for R
conditions of input voltage and load current. The simplest
way of accomplishing this is to apply load currents of
minimum, maximum and several points in between. At
each load current, input voltage is varied from minimum
to maximum while observing the settling waveform.
If large temperature variations are expected for the system,
stability checks should also be done at the temperature
extremes. There can be significant temperature varia-
tions in several key component parameters which affect
stability; in particular, input and output capacitor value
and their ESR, and inductor permeability. The external
converter parametric variations also need some consid-
eration especially the transfer function from the ITH/VC
pin voltage to the output variable (voltage or current). The
LTC4000 parameters that vary with temperature include
the transconductance and the output resistance of the
error amplifiers (A4-A7). For modest temperature varia-
tions, conservative over damping under worst-case room
temperature conditions is usually sufficient to guarantee
adequate stability at all temperatures.
One measure of stability margin is to vary the selected
values of both R
binations. If the regulator response remains reasonably
well damped under all conditions, the regulator can be
considered fairly tolerant of parametric variations. Any
tendency towards an under damped (ringing) response
indicates that a more conservative compensation may
be needed.
C
and C
C
and C
C
by 2:1 in all four possible com-
C
should be checked under all
4000f