W181 Cypress Semiconductor, W181 Datasheet - Page 4

• Manufacturer Part Number: W181
• Description: Peak Reducing EMI Solution
• Manufacturer: Cypress Semiconductor

Spread Spectrum Frequency Timing Genera-
tion
The device generates a clock that is frequency modulated in
order to increase the bandwidth that it occupies. By increasing
the bandwidth of the fundamental and its harmonics, the am-
plitudes of the radiated electromagnetic emissions are re-
duced. This effect is depicted in Figure 2.
As shown in Figure 2, a harmonic of a modulated clock has a
much lower amplitude than that of an unmodulated signal. The
reduction in amplitude is dependent on the harmonic number
and the frequency deviation or spread. The equation for the
reduction is:
dB = 6.5 + 9*log
MAX.
MIN.
Figure 2. Clock Harmonic with and without SSCG Modulation Frequency Domain Representation
SSFTG
10
(P) + 9*log
Frequency Span (MHz)
Center Spread
10
(F)
Typical Clock
Figure 3. Typical Modulation Profile
4
Where P is the percentage of deviation and F is the frequency
in MHz where the reduction is measured.
The output clock is modulated with a waveform depicted in
Figure 3. This waveform, as discussed in “Spread Spectrum
Clock Generation for the Reduction of Radiated Emissions” by
Bush, Fessler, and Hardin produces the maximum reduction
in the amplitude of radiated electromagnetic emissions. Figure
3 details the Cypress spreading pattern. Cypress does offer
options with more spread and greater EMI reduction. Contact
your local Sales representative for details on these devices.
Spectrum
Enabled
Spread
EMI Reduction
Frequency Span (MHz)
Down Spread
Spectrum
Spread
Non-
W181