TDA7402_07 STMICROELECTRONICS [STMicroelectronics], TDA7402_07 Datasheet - Page 19

• Manufacturer Part Number: TDA7402_07
• Description: Car radio signal processor
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

TDA7402
4.3
4.3.1
4.3.2
Pause detector / MUX-output
The pin number 40 (Pause/MUX) is configurable for two different functions:
1.
2.
Loudness
There are four parameters programmable in the loudness stage:
Attenuation
Figure 4
Figure 4.
dB
During pause detector OFF this pin is used as a mono output of the main input selector.
This signal is often used to drive a level/equalizer display on the car radio front panel.
During pause detector ON the pin is used to define the time constant of the detector by
an external capacitor. The pause detector is driven by the internal stereo decoder
outputs in order to use pauses in the FM signal for alternate frequency jumps. If the
signal level of both stereo decoder channels is outside the programmed voltage
window, the external capacitor is abruptly discharged. Inside the pause condition the
capacitor is slowly recharged by a constant current of 25µA. The pause information is
also available via I
-10.0
-15.0
-20.0
-25.0
-5.0
0.0
10.0
shows the attenuation as a function of frequency at f
Loudness attenuation @ f
2
C Bus (see I
100.0
2
C Bus programming).
P
= 400Hz.
Hz
1.0K
P
= 400Hz
Audioprocessor part
10.0K
19/71