TDA7501TR STMICROELECTRONICS [STMicroelectronics], TDA7501TR Datasheet - Page 15

no-image

TDA7501TR

Manufacturer Part Number
TDA7501TR
Description
Line driver for digital car radio Signal processor (DSPLD)
Manufacturer
STMICROELECTRONICS [STMicroelectronics]
Datasheet
TDA7501
5
5.1
5.2
Reference concept
For the input section the TDA7501 generates the internal reference voltage by multiplying
the V33 voltage by 1.2575.
The V33 voltage is also buffered and fed back to the CODEC where it is used to generate all
necessary references. For best performance it is recommended to filter the V33 reference
pin by means of a passive second order lowpass as shown in
a direct DC coupling between the TDA7501 and the DSP because of the accurate matching
of DC levels. On the output side the TDA7501 offers two main modes: a single supply and a
dual supply mode.
Dual supply mode
In this mode the outputs are able to provide up to 4V rms with a minimum supply V
as well as a output reference voltage set to half of V
'1').
If the switch D1/byte mode select is open the output reference voltage must be defined
externally e.g. a zener diode with RC lowpass.
If the switch is closed the reference voltage will be half of V
has to be added.
Single supply mode
If V
2.8V rms .
The output reference voltage pin can be left open or otherwise the internal voltage divider
can be used to generate for the outputs a V
Figure 13. Reference voltage generation
CC
and V
dd
are connected to a single supply the maximum possible output swing is about
TDA7500
TDA7501
CC
/2 reference.
CC
(bit D0 of the mode select byte set to
CC
Figure
and only an external capacitor
13. This concept allows
Reference concept
CC
of 12V
15/29

Related parts for TDA7501TR