LAN8187_06 SMSC [SMSC Corporation], LAN8187_06 Datasheet - Page 32

• Manufacturer Part Number: LAN8187_06
• Manufacturer: SMSC [SMSC Corporation]

±15kV ESD Protected MII/RMII Fast-Ethernet PHY with HP Auto-MDIX and SMSC flexPWR
Datasheet
SMSC LAN8187/LAN8187I
4.11
4.12
4.12.1
Table 4.4, “Boot Strapping Configuration Resistors,” on page
TX_ER/TXD4 mode. The default setting is high (nINT mode).
The PHY ADDRESS bits are latched on the rising edge of the internal reset (nreset). The 5-bit address
word[0:4] is input on the LED1, LED2, LED3, LED4, GPO1 output pins. The default setting is all high
5'b1_1111.
The address lines are strapped as defined in the diagram below. The LED outputs will automatically
change polarity based on the presence of an external pull-down resistor. If the LED pin is pulled high
(by an internal 100K pull-up resistor) to select a logical high PHY address, then the LED output will
be active low. If the LED pin is pulled low (by an external pull-down resistor (see
Strapping Configuration Resistors,” on page
will then be an active high output.
To set the PHY address on the LED pins without LEDs or on the GPO1 or CRS pin, float the pin to
set the address high or pull-down the pin with an external resistor (see
Configuration Resistors,” on page
The Digital I/O pins on the LAN8187/LAN8187I are variable voltage to take advantage of low power
savings from shrinking technologies. These pins can operate from a low I/O voltage of +1.6V up to
+3.6V. Due to this low voltage feature addition, the system designer needs to take consideration as
for two aspects of their design. Boot strapping configuration and I/O voltage stability.
Boot Strapping Configuration.
Due to a lower I/O voltage, a lower strapping resistor needs to be used to ensure the strapped
configuration is latched into the PHY device at power-on reset.
PHY Address Strapping and LED Output Polarity Selection
Variable Voltage I/O
LED output = active low
Phy Address = 1
Table 4.4 Boot Strapping Configuration Resistors
Figure 4.5 PHY Address Strapping on LED’s
I/O voltage
3.0 to 3.6
2.0 to 3.0
VDD
~270 ohms
32) to GND to set the address low. See the figure below:
DATASHEET
10k ohm resistor
7.5k ohm resistor
Pull-up/Pull-down Resistor
LED1-LED4
32
32) to select a logical low PHY address, the LED output
~10K ohms
TM
LED output = active high
Phy Address = 0
32) to VSS to set the device in
Table 4.4, “Boot Strapping
~270 ohms
Revision 1.0 (12-14-06)
LED1-LED4
Table 4.4, “Boot