LAN83C180_01 SMSC [SMSC Corporation], LAN83C180_01 Datasheet - Page 20

• Manufacturer Part Number: LAN83C180_01
• Description: 10/100 Fast Ethernet PHY Transceiver
• Manufacturer: SMSC [SMSC Corporation]

EXTERNAL COMPONENTS
Connecting an External 25MHz Reference
If an external clock is used then it should be driven into the REFCLK input, and XTAL1 must be connected to
OSCVDD. XTAL2 must be left unconnected.
nRESET Pull-up Resistor
This resistor is required regardless of whether nRESET is used externally.
RX Input Decoupling
The method of using a split input load resistor and de-coupling the center tap reduces common mode noise.
Crystal Oscillator
For IEEE802.3 compliance the oscillator must run at 25MHz ±100ppm. The LAN83C180 on-chip circuitry contributes
less than 40ppm variability to the oscillator frequency, therefore the crystal must be specified to 60ppm. This must
include variations due to temperature and aging.
External capacitors are required on the XTAL1 & XTAL2 pins. The values of these capacitors are dependent on the
power dissipation and the equivalent series resistance of the chosen crystal, as follows:
Let P
and ESR = equivalent series resistance of the crystal in W.
If P
If P
Tracking to the crystal and the capacitors must be as short as possible. Other signal paths must not cross the area.
The LAN83C180 is supported by magnetics from the following vendors:
SMSC DS – LAN83C180
C
C
<2.6mW then C
>2.6mW then C
C
= power dissipation of the crystal in mW,
VENDOR
HALO
HALO
Pulse
Valor
Bel
1
1
ESR
& C
& C
2
2
ESR
are determined by the power dissipation of the crystal:
are determined by the loop gain:
Pc
S558-5999-39
H1012
ST6118
TG110-S050N2
TG22-3506ND
MAGNETICS
Page 20
Rev. 08/24/2001