AT89C51RB2-RLTCM ATMEL [ATMEL Corporation], AT89C51RB2-RLTCM Datasheet - Page 79

• Manufacturer Part Number: AT89C51RB2-RLTCM
• Description: 8-bit Microcontroller with 16K/ 32K Bytes Flash
• Manufacturer: ATMEL [ATMEL Corporation]

Warm Reset
Watchdog Reset
4180B–8051–04/03
Table 1. Minimum Reset Capacitor Value for a 50 kΩ Pull-down Resistor
Note:
To achieve a valid reset, the reset signal must be maintained for at least 2 machine
cycles (24 oscillator clock periods) while the oscillator is running. The number of clock
periods is mode independent (X2 or X1).
As detailed in Section “Watchdog Timer”, page 59, the WDT generates a 96-clock
period pulse on the RST pin. In order to properly propagate this pulse to the rest of the
application in case of external capacitor or power-supply supervisor circuit, a 1 kΩ resis-
tor must be added as shown Figure 32.
Figure 32. Reset Circuitry for WDT Reset-out Usage
Start-Up Time
Oscillator
20 ms
These values assume V
on/off sequences is too fast, the power-supply de-coupling capacitors may not be fully
discharged, leading to a bad reset sequence.
5 ms
VDD
VDD
VSS
+
RST
1K
820 nF
2.7 µF
1 ms
DD
RST
starts from 0V to the nominal value. If the time between 2
VDD
VSS
P
VDD Rise Time
1.2 µF
3.9 µF
10 ms
AT89C51RB2/RC2
From WDT
Reset Source
To CPU Core
and Peripherals
To Other
On-board
Circuitry
100 ms
(1)
12 µF
12 µF
79