BD9267KUT ROHM [Rohm], BD9267KUT Datasheet - Page 8
![no-image](/images/no-image-200.jpg)
BD9267KUT
Manufacturer Part Number
BD9267KUT
Description
White LED Diver for Backlight of Medium/Large-sized LCDs
Manufacturer
ROHM [Rohm]
Datasheet
1.BD9267KUT.pdf
(31 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
BD9267KUT-GE2
Manufacturer:
ROHM/罗姆
Quantity:
20 000
BD9267KUT
●Pin Function Descriptions
www.rohm.com
© 2012 ROHM Co., Ltd. All rights reserved.
TSZ22111・15・001
G1-G16
S1-S16
D1-D16
VREF5V
Connect to external FET’s source terminal of LED constant current driver。Through the operations of constant current
driver, all CHs of S1-S16 terminals are outputted the set voltages at addresses of 02h, 03h, and S1-S16 proceed the
constant current operation.
By monitoring the voltage of this terminal, the external resistance SHORT detection of each CH and external MOS
SHORT during Drain-Source detection proceed.
When Dimming=HIGH, external resistance SHORT detection proceeds, and output the errors.
When Dimming=LOW, external MOS Drain-Source SHORT detection proceeds, and output the errors.
At output terminal of LED constant current driver, drain of external FET is connected. By monitoring the voltage of this
terminal, LED OPEN detection and LED SHORT detection of each terminal proceed.
When Dimming=HIGH, if LED is in SHORT mode or OPEN mode, error signals are outputted.
LED OPEN protection detected voltage ・・・0.1V(typ.)
LED SHORT protection detected voltage・・・5.0V(typ.)・・・(It can be changed by setting the LSP terminal. Details are
given in LSP Pin Description.)
When Dimming = LOW, the abnormal state when Dimming = HIGH just before continues. In other words, when
Dimming=HIGH and the abnormal state is detected, the error signal is still outputted even turned to Dimming=LOW.
To prevent the mistake of detection caused by the time change of state, abnormal detection mask can be set at address
of 04h.
External FET gate driving terminal of LED constant current driver, operating range : 0~5V.
The VREF5V pin is used to output power (5V) to the internal block of the IC and serves as a main power supply for the
internal circuit of the IC. Install a ceramic capacitor as close to this pin as possible in order to stabilize the power supply
voltage.
At D1~16 pin
① LED OPEN detection(when PWM=H)
② LED SHORT detection(when PWM=H)
At S1~16 pin
③ RESISTOR SHORT detection(when PWM=H)
④ MOS SHORT detection(when PWM=L)
are detected, then the error signals are outputted.
( ( ( (
( ( ( (
( ( ( (
3,6,9,12,15,18,21,24,25,28,31,34,37,40,43,46PIN
2,5,8,11,14,17,20,23,26,29,32,35,38,41,44,47PIN
1,4,7,10,13,16,19,22,27,30,33,36,39,42,45,48PIN
( ( ( (
49PIN
) ) ) )
) ) ) )
) ) ) )
8/28
) ) ) )
Figure 10. LED Protected operation
TSZ02201-0F1F0C100050-1-2
03.Aug.2012 Rev.001
Datasheet