E-L8150 STMICROELECTRONICS [STMicroelectronics], E-L8150 Datasheet - Page 13
![no-image](/images/no-image-200.jpg)
E-L8150
Manufacturer Part Number
E-L8150
Description
Brushless motor predriver
Manufacturer
STMICROELECTRONICS [STMicroelectronics]
Datasheet
1.E-L8150.pdf
(37 pages)
L8150
4
4.1
4.2
4.3
4.4
General description
Drive stage
Voltage-controlled PWM drive.
Smooth drive architecture (see following dedicated paragraph).
External sense resistor as current limiter.
FR terminal: Low = Forward, High or Open = Backward.
Output
U, V, W upper and lower arm power transistors control output (6 outputs)
CMOS level (Low: 0V, High: 5V, need output buffer)
dead time (0, 1usec, 1.5usec selectable).
I/O
FG output: multiplexed by Hall signal (open drain)
(Hall signal after digital filter are used)
Forward/backward control
FAULT output: monitor signal for protection operation (low active, open drain), active if one
of over voltage, lower voltage, thermal protection, Hall sensor fail protection is operative
Torque optimizer: controlled by analog input
DM output is the monitor signal of Hall input sequence:
Hall Sensor Input Terminals
There are 2 types of application, Hall device and Hall IC
Hall Device application: differential inputs with some bias
Hall IC application: one input is fixed around VREG/2 by resistor divider between VREG and
GND the other input comes from Hall IC whose span is between 0 and 5V.
–
–
–
IF UVW hall signal sequence is as the direction set by FR, DM=H
IF UVW hall signal sequence is opposite for the direction set by FR, DM=L
Reset or some case in which UVW sequence can not be monitored, DM=H (Hall
signals after digital filter are used for this control).
General description
13/37