MLX90609EEA-R2 MELEXIS [Melexis Microelectronic Systems], MLX90609EEA-R2 Datasheet - Page 9

• Manufacturer Part Number: MLX90609EEA-R2
• Description: Angular Rate Sensor (Standard version)
• Manufacturer: MELEXIS [Melexis Microelectronic Systems]

The MLX90609 has a serial communication interface compatible with Serial Peripheral Interface
(SPI). Likewise SPI the Serial Interface of the MLX90609 specifies four signals:
The MLX90609 always operates as a slave. Therefore only MISO pin is an output.
The MLX90609 is selected when the SS pin is low (see Figure 5-2
data will not be accepted via the MOSI pin. The serial output pin (MISO) will remain in a high
impedance state. High level of SS forces the serial interface into the start state of data exchange.
Data is serially transmitted to the MLX90609 in 8 bit words (an instruction byte) and in 16 bit data
words. Data is serially received from the MLX90609 in 16 bit words (an answer word). Most
Significant Bit (MSB) is the first bit transmitted and received.
Transmission:
After the device is selected with SS going low, the instruction byte will be received by the
MLX90609. On each rising edge of SCLK data from MOSI enter into an internal 8-bit shift register.
The accepted instruction byte contains the op-code that defines the operations to be performed.
Along with op-code this byte can also contain information such as EEPROM address or ADC mode
(to be setup).
Reception:
After the 8th bit is received to the shift register, the command will be executed by the MLX90609.
The format of the outgoing data is defined by the received instruction. All instructions evoke an
answer. A full communication cycle (transmitting an instruction and receiving the full answer) is
finished after 24th clock of the SCLK. Communication can be terminated by putting SS high.
Some remarks:
390109060901
Rev 008
5.2 Communication with the MLX90609 through the SPI
serial clock (SCLK);
master data output, slave data input (MOSI);
master data input, slave data output (MISO); and
slave select ( SS ).
If an invalid op-code is received, it is rejected and the corresponding data is ignored. In this
case a special
It's recommended to use synchronization by SS after every data exchange to prevent a data
distortion.
If high level is applied to SS during an instruction byte transmission, the command will be
ignored.
If high level is applied to SS during the answer reception, the answer will be truncated. This
can be used to limit the reading of the answer to e.g. one byte only (see Figure 5-3).
“refusal answer”
will be generated.
Page 9 of 22
Angular Rate Sensor (Standard version)
MLX90609
Figure 5-2
). When SS pin is high,
Data Sheet
February/08