ISD-T360 ETC [List of Unclassifed Manufacturers], ISD-T360 Datasheet - Page 90

• Manufacturer Part Number: ISD-T360
• Description: VoiceDSP Digital Speech Processor with Master/Slave, Full-Duplex Speakerphone, Multiple Flash and ARAM/DRAM Support
• Manufacturer: ETC [List of Unclassifed Manufacturers]

NOTE
Example
SV
Selects the vocabulary table to be used for voice synthesis. The vocabulary type is set according to
the 1-byte type parameter:
The host is responsible for selecting the current vocabulary, with SV command, before using an SAS,
SO, SS or SW command. Each external vocabulary table has a unique id which is part of the vocabu-
lary internal header (See the IVS User’s Guide for more details). If type is 1 or 2, the VoiceDSP processor
searches for the one byte id parameter in each vocabulary table header until a match is found.
If the id parameter does not point to a valid IVS vocabulary, ERR_PARAM is set in the error word.
Example
SW
Plays n words, indexed by word
On completion, the EV_NORMAL_END bit in the status word is set, and the MWRQST signal goes low.
The state then changes to IDLE.
If one of the words is not defined in the current vocabulary, or if it is an IVS control or option code, or
if n > 8, ERR_PARAM is reported.
2-50
SSM 01
Byte sequence:
Description:
SV 02 03
Byte sequence:
Description:
0
1
2
3-7
Only commands that are specified in Table 2-3, are active during all speakerphone modes (other
than 0).
For compatibility only.
External vocabulary in ROM.
External vocabulary in Flash.
Reserved.
Microcontroller
VoiceDSP
Put the VoiceDSP processor into Speakerphone mode, and set the speakerphone to full-duplex mode.
Microcontroller
VoiceDSP
Select the vocabulary with vocabulary-id 3, which resides on a Flash, as the current
vocabulary.
Set Vocabulary Type type id
Say Words n word
1
to word
n
. The VoiceDSP processor state changes to SYNTHESIS.
1
. . . word
n
20
20
Voice Solutions in Silicon™
2F
2F
02
02
03
03
01
01