SG6846CD ETC1 [List of Unclassifed Manufacturers], SG6846CD Datasheet - Page 3

• Manufacturer Part Number: SG6846CD
• Description: Highly-Integrated Green-Mode PWM Controller
• Manufacturer: ETC1 [List of Unclassifed Manufacturers]

Highly-Integrated Green-Mode PWM Controller
PIN DESCRIPTIONS
BLOCK DIAGRAM (OTP LATCH VERSION)
© System General Corp.
Version 1.0(IAO33.0008.B0)
1
2
3
4
5
6
7
8
Pin No. Symbol
GND
FB
VIN
RI
RT
SENSE
VDD
GATE
Function
Ground
Feedback
Line-voltage
Detection
Reference
Setting
Temperature
Detection
Current Sense
Power Supply
Driver Output
Description
Ground.
The signal from the external compensation circuit is fed into this pin. This FB pin and the
current-sense signal from Pin 6 determine the PWM duty cycle.
Line-voltage detection. The line-voltage detection is used for brownout protection with
hysteresis. Constant output power limit over universal AC input range is also achieved using
this VIN signal. It is suggested to add low pass filter to filter out line ripple on bulk capacitor.
A resistor from the RI pin to ground will generate a reference current source inside SG6846.
This determines the switching frequency. Increasing the resistance will reduce the switching
frequency. Using a 26kΩ resistor Ri results in a 65kHz switching frequency.
For over-temperature protection. An external NTC thermistor is connected from this pin to
GND pin. The impedance of the NTC will decrease at high temperatures. Once the voltage
of the RT pin drops below a threshold, PWM output will be disabled.
Current sense. The sensed voltage is used for peak-current-mode control and
cycle-by-cycle current limiting. If the switching current is higher than 2/3 of the peak-current
threshold for longer than 96ms, over-current protection will be activated. This two-level OCP
feature is especially suitable for SMPS with surge current output.
Power Supply. The internal protection circuit will disable PWM output when VDD over
voltage.
The totem-pole output driver for the power MOSFET. A soft driving waveform is
implemented for improved EMI.
- 3 -
Product Specification
www.sg.com.tw
Sep. 30, 2004
SG6846