AOZ1210-EVA AOSMD [Alpha & Omega Semiconductors], AOZ1210-EVA Datasheet - Page 4

• Manufacturer Part Number: AOZ1210-EVA
• Manufacturer: AOSMD [Alpha & Omega Semiconductors]

Quick Start Guide
1. Connect the terminals of load to +V
2. Connect the DC power supply to +V
3. Connect EN pin to +V
4. Turn on DC power supply and evaluation circuit will start.
5. Measure input voltage at the +V
6. Measure output voltage at the +V
7. Use an oscilloscope to monitor input ripple voltage right across input capacitor C1.
8. Use an oscilloscope to monitor output ripple voltage right across output capacitor C2.
Rev. 1.0 December 2007
power supply and evaluation board.
load and evaluation board.
IN
or any voltage source which is between 2.5V and 27V.
IN
OUT
pin and GND pins to eliminate the effect of voltage drop on wire between DC
OUT
IN
pin and GND pins to eliminate the effect of the voltage drop on wire between
pin and GND pins. Set DC power supply voltage to between 4.5V and 27V.
pins and GND pins. Set load current to between 0A and 2A.
Figure 3. Bottom Layer
www.aosmd.com
AOZ1210-EVA
Page 4 of 5