NCV47711PDAJR2G ONSEMI [ON Semiconductor], NCV47711PDAJR2G Datasheet - Page 8

• Manufacturer Part Number: NCV47711PDAJR2G
• Description: 5 V to 20 V Adjustable LDO with Adjustable Current Limit and 3.3 V Logic Compatible Enable Input
• Manufacturer: ONSEMI [ON Semiconductor]

General
All measurements are performed using short pulse low duty
cycle techniques to maintain junction temperature as close
as possible to ambient temperature.
Output Voltage
The output voltage parameter is defined for specific
temperature, input voltage and output current values or
specified over Line, Load and Temperature ranges.
Line Regulation
The change in output voltage for a change in input voltage
measured for specific output current over operating ambient
temperature range.
Load Regulation
The change in output voltage for a change in output current
measured for specific input voltage over operating ambient
temperature range.
Dropout Voltage
The input to output differential at which the regulator output
no longer maintains regulation against further reductions in
input voltage. It is measured when the output voltage V
has dropped −2% from the nominal value obtained at V
V
and minimum input supply requirements affect the dropout
level.
Quiescent and Disable Currents
Quiescent Current (I
current (measured through the LDO input pin) and the
output load current. If Enable pin is set to LOW the regulator
out_nom
+ 8.5 V. The junction temperature, load current,
q
) is the difference between the input
http://onsemi.com
DEFINITIONS
in
out
=
8
reduces its internal bias and shuts off the output, this term is
called the disable current (I
Current Limit
Current Limit is value of output current by which output
voltage drops below 90% of its nominal value.
PSRR
Power Supply Rejection Ratio is defined as ratio of output
voltage and input voltage ripple. It is measured in decibels
(dB).
Line Transient Response
Typical output voltage overshoot and undershoot response
when the input voltage is excited with a given slope.
Load Transient Response
Typical output voltage overshoot and undershoot response
when the output current is excited with a given slope
between low−load and high−load conditions.
Thermal Protection
Internal thermal shutdown circuitry is provided to protect
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 175°C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
The power dissipation level is maximum allowed power
dissipation for particular package or power dissipation at
which the junction temperature reaches its maximum
operating value, whichever is lower.
DIS
).