T89C5115_08 ATMEL [ATMEL Corporation], T89C5115_08 Datasheet - Page 35

• Manufacturer Part Number: T89C5115_08
• Description: Low Pin Count 8-bit Microcontroller with A/D Converter and 16 KBytes Flash Memory
• Manufacturer: ATMEL [ATMEL Corporation]

Status of the Flash Memory
Selecting FM1
Loading the Column Latches
4128G–8051–02/08
The bit FBUSY in FCON register is used to indicate the status of programming.
FBUSY is set when programming is in progress.
The bit ENBOOT in AUXR1 register is used to map FM1 from F800h to FFFFh.
Any number of data from 1 byte to 128 Bytes can be loaded in the column latches. This
provides the capability to program the whole memory by byte, by page or by any number
of Bytes in a page.
When programming is launched, an automatic erase of the locations loaded in the col-
umn latches is first performed, then programming is effectively done. Thus no page or
block erase is needed and only the loaded data are programmed in the corresponding
page.
The following procedure is used to load the column latches and is summarized in
Figure 14:
•
•
•
•
•
•
Save then disable interrupt and map the column latch space by setting FPS bit.
Load the DPTR with the address to load.
Load Accumulator register with the data to load.
Execute the MOVX @DPTR, A instruction.
If needed loop the three last instructions until the page is completely loaded.
unmap the column latch and Restore Interrupt
35