DSPIC30F6010A MICROCHIP [Microchip Technology], DSPIC30F6010A Datasheet - Page 77

• Manufacturer Part Number: DSPIC30F6010A
• Description: High-Performance, 16-bit Digital Signal Controllers
• Manufacturer: MICROCHIP [Microchip Technology]

11.0
This section describes the second 32-bit General
Purpose (GP) Timer module (Timer4/5) and associated
operational modes.
block diagram of the 32-bit Timer4/5 Module.
Figure 11-2
as two independent 16-bit timers, Timer4 and Timer5,
respectively.
FIGURE 11-1:
© 2011 Microchip Technology Inc.
Note:
Note:
Note:
T5IF
Event Flag
TIMER4/5 MODULE
T4CK
This data sheet summarizes features of
this group of dsPIC30F devices and is not
intended to be a complete reference
source. For more information on the CPU,
peripherals, register descriptions and gen-
eral device functionality, refer to the
“dsPIC30F Family Reference Manual”
(DS70046).
Timer4 is a Type B timer and Timer5 is a
Type C timer. Please refer to the appropri-
ate timer type in
Characteristics”.
and
Data Bus<15:0>
(T4CON<6>)
Figure 11-3
Timer Configuration bit T45, T4CON(<3>) must be set to ‘
control bits are respective to the T4CON register.
Read TMR4
TGATE
Write TMR4
Figure 11-1
0
1
32-BIT TIMER4/5 BLOCK DIAGRAM
Reset
Equal
show Timer4/5 configured
Section 24.0 “Electrical
16
TMR5HLD
depicts the simplified
MSB
TMR5
PR5
Comparator x 32
16
16
TMR4
LSB
PR4
Q
Q
CK
D
Gate
Sync
T
CY
TGATE(T4CON<6>)
dsPIC30F6010A/6015
The Timer4/5 module is similar in operation to the
Timer2/3
differences, which are listed below:
• The Timer4/5 module does not support the ADC
• Timer4/5 cannot be utilized by other peripheral
The operating modes of the Timer4/5 module are
determined by setting the appropriate bit(s) in the 16-bit
T4CON and T5CON SFRs.
For 32-bit timer/counter operation, Timer4 is the lsw
and Timer5 is the msw of the 32-bit timer.
Event Trigger feature
modules such as Input Capture and Output Compare
Note:
1
’ for a 32-bit timer/counter operation. All
1 x
0 1
0 0
module.
For 32-bit timer operation, T5CON control
bits are ignored. Only T4CON control bits
are used for setup and control. Timer4
clock and gate inputs are utilized for the
32-bit timer module, but an interrupt is
generated with the Timer5 Interrupt Flag
(T5IF) and the interrupt is enabled with the
Timer5 Interrupt Enable bit (T5IE).
Sync
TON
However,
TCKPS<1:0>
1, 8, 64, 256
Prescaler
2
there
DS70150E-page 77
are
some