HCPL4200 ETC, HCPL4200 Datasheet
HCPL4200
Available stocks
Related parts for HCPL4200
HCPL4200 Summary of contents
Page 1
Optically Coupled 20 mA Current Loop Receiver Technical Data Features • Data Output Compatible with LSTTL, TTL and CMOS • Baud Data Rate at 1400 Metres Line Length • Guaranteed Performance over Temperature (0°C to 70°C) • Guaranteed ...
Page 2
Ordering Information Specify part number followed by Option Number (if desired). HCPL-4200# XXX Option data sheets available. Contact your Hewlett-Packard sales representative or authorized distributor for information. Package Outline Drawings – 8 Pin DIP Package with Gull Wing Surface Mount ...
Page 3
Thermal Profile (Option #300) Figure 1. Maximum Solder Reflow Thermal Profile. (Note: Use of non-chlorine activated fluxes is recommended.) Regulatory Information The HCPL-4200 has been approved by the following organizations: Insulation and Safety Related Specifications Parameter Min. External Air Gap ...
Page 4
Absolute Maximum Ratings (No Derating Required up to 70°C) Storage Temperature ......................................................... -55°C to +125°C Operating Temperature ....................................................... -40°C to +85°C Lead Solder Temperature ..... 260°C for 10 s (1.6 mm below seating plane) Supply Voltage – V ...................................................................... 0 ...
Page 5
DC Electrical Specifications For 0°C T 70°C, 4 noted. See note 13. Parameter Symbol Min. Typ. Max. Units Mark State Input I MI Current Mark State Input V MI Voltage Space State Input ...
Page 6
Switching Specifications For 0°C T 70°C, 4 otherwise noted. See note 13. Parameter Symbol Propagation Delay Time t to Logic High Output Level Propagation Delay Time t to Logic Low Output Level Propagation Delay Time t ...
Page 7
Notes µs pulse width, 300 pps. 2. Derate linearly above 70°C free air temperature at a rate of 1.6 mW/ °C. Proper application of the derating factors will prevent IC junction temperatures from exceeding 125°C for ambient temperatures ...
Page 8
Figure 8. Test Circuit for and t PHL PLH r Figure 10. Typical Propagation Delay vs. Temperature. Figure 12. Test Circuit for PZH PZL 1-330 . Figure 9. Waveforms ...
Page 9
... Simplex The simplex configuration, whether point to point or multi- drop, gives unidirectional data flow from transmitter to receiver(s). This is the simplest Figure 15 ...
Page 10
Figure 17. Simplex Current Loop System Configurations for (a) Point-to-Point, (b) Multidrop. and OFF states. This non-isolated active transmitter provides a nominal 20 mA loop current for the listed values and Figure 18. ...
Page 11
Figure 18. Recommended Non-Isolated Active Transmitter with HCPL-4200 Isolated Receiver for Simplex Point-to-Point 20 mA Current Loop. receiver, can be used at the isolated end of current loops. Cross talk and common mode coupling are greatly reduced when optical isolation ...
Page 12
With this combination of HCPL-4100/ -4200 optocouplers, specific current loop noise immunity is provided, i.e., minimum SPACE state current noise immunity is 1 mA, MARK state noise immunity is 8 mA. Figure 22. ...