EL7563C Elantec Semiconductor, EL7563C Datasheet - Page 16

• Manufacturer Part Number: EL7563C
• Description: Monolithic 4 Amp DC:DC Step-down Regulator
• Manufacturer: Elantec Semiconductor

EL7563C
Monolithic 4 Amp DC:DC Step-down Regulator
Thermal Management
The EL7563C utilizes “fused lead” packaging technol-
ogy in conjunction with the system board layout to
achieve a lower thermal resistance than typically found
in standard SO20 packages. By fusing (or connecting)
multiple external leads to the die substrate within the
package, a very conductive heat path is created to the
outside of the package. This conductive heat path MUST
then be connected to a heat sinking area on the PCB in
order to dissipate heat out and away from the device.
The conductive paths for the EL7563CM package are
the fused leads: # 6, 7, 11, 12, and 13. If a sufficient
amount of PCB metal area is connected to the fused
package leads, a junction-to-ambient resistance of
43°C/W can be achieved (compared to 85°C/W for a
standard SO20 package). The general relationship
between PCB heat-sinking metal area and the thermal
resistance for this package is shown in the Performance
Curves section of this data sheet. It can be readily seen
that the thermal resistance for this package approaches
an asymptotic value of approximately 43°C/W without
any airflow, and 33°C/W with 100 LFPM airflow. Addi-
tional information can be found in Application Note #8
(Measuring the Thermal Resistance of Power Surface-
Mount Packages). For a thermal shutdown die junction
temperature of 135°C, and power dissipation of 1.5W,
the ambient temperature can be as high as 70°C without
airflow. With 100 LFPM airflow, the ambient tempera-
ture can be extended to 85°C.
The EL7563CRE utilizes the 28-pin HTSSOP package.
The majority if heat is dissipated through the heat pad
exposed at the bottom of the package. Therefore, the
heat pad needs to be soldered to the PCB. The thermal
resistance for this package is better than that of the
SO20. Actual test results are available from Elantec
Applications staff. The actual junction temperature can
be measured at VTJ pin.
Since the thermal performance of the IC is heavily
dependent on the board layout, the system designer
should exercise care during the design phase to ensure
that the IC will operate under the worst-case environ-
mental conditions.
16
Layout Considerations
The layout is very important for the converter to func-
tion properly. Power Ground ( ) and Signal Ground (---)
should be separated to ensure that the high pulse current
in the Power Ground never interferes with the sensitive
signals connected to Signal Ground. They should only
be connected at one point (normally at the negative side
of either the input or output capacitor.)
The trace connected to the FB pin is the most sensitive
trace. It needs to be as short as possible and in a “quiet”
place, preferably between PGND or SGND traces.
In addition, the bypass capacitor connected to the VDD
pin needs to be as close to the pin as possible.
The heat of the chip is mainly dissipated through the
PGND pins. Maximizing the copper area around these
pins is preferable. In addition, a solid ground plane is
always helpful for the EMI performance.
The demo board is a good example of layout based on
these principles. Please refer to the EL7563C Applica-
tion Brief for the layout.