HMC602LP4E HITTITE [Hittite Microwave Corporation], HMC602LP4E Datasheet - Page 7

• Manufacturer Part Number: HMC602LP4E
• Description: 70 dB, LOGARITHMIC DETECTOR / CONTROLLER, 1 - 8000 MHz
• Manufacturer: HITTITE [Hittite Microwave Corporation]

12 - 24
12
Pin Descriptions
Application & Evaluation PCB Schematic
Notes
Note 1: The HMC602LP4 & HMC602LP4E evaluation boards are pre-assembled for single-ended input, and detector/RSSI mode.
Note 2: For detector mode, connect high impedance volt meter to the LOGOUT port, and make no connection to VSET. LOGOUT
Note 3: For controller mode, remove R9 and install 0 ohm resistor (R11), then make appropriate connection to LOGOUT and VSET.
Package Base
Pin Number
21, 22
is shorted to VSET by R9, as required for detector mode.
In controller mode, the LOGOUT output can be used to drive a variable gain amplifi er, or a variable attenuator, either
directly or through a buffer or microcontroller. VSET should be connected to an external supply, typically between +0.6
and +1.9V.
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
20 Alpha Road, Chelmsford, MA 01824 Phone: [phone] Fax: [phone]
Function
GND
N/C
(Continued)
Exposed paddle must be connected to RF and DC ground.
The user should not connect to these pins.
v03.0209
Order On-line at www.hittite.com
DETECTOR / CONTROLLER, 1 - 8000 MHz
Description
HMC602LP4 / 602LP4E
70 dB, LOGARITHMIC
Interface Schematic