AK4646EN AKM [Asahi Kasei Microsystems], AK4646EN Datasheet - Page 26

• Manufacturer Part Number: AK4646EN
• Description: Stereo CODEC with MIC/SPK-AMP
• Manufacturer: AKM [Asahi Kasei Microsystems]

■
The AK4646 becomes EXT Master Mode by setting PMPLL bit = “0” and M/S bit = “1”. Master clock is input from
MCKI pin, the internal PLL circuit is not operated. The clock required to operate is MCKI (256fs, 512fs or 1024fs). The
input frequency of MCKI is selected by FS1-0 bits (Table 13).
The S/N of the DAC at low sampling frequencies is worse than at high sampling frequencies due to out-of-band noise.
The out-of-band noise can be improved by using higher frequency of the master clock. The S/N of the DAC output
through LOUT/ROUT pins at fs=8kHz is shown in Table 14.
MCKI should always be present whenever the ADC or DAC is in operation (PMADL bit = “1”, PMADR bit = “1” or
PMDAC bit = “1”). If MCKI is not provided, the AK4646 may draw excess current and it is not possible to operate
properly because utilizes dynamic refreshed logic internally. If MCKI is not present, the ADC and DAC should be in the
power-down mode (PMADL=PMADR=PMDAC bits = “0”).
MS0557-E-02
EXT Master Mode (PMPLL bit = “0”, M/S bit = “1”)
Mode
0
1
2
3
Table 13. MCKI Frequency at EXT Master Mode (PMPLL bit = “0”, M/S bit = “1”)
FS3-2 bits
Don’t care
Don’t care
Don’t care
Don’t care
Table 14. Relationship between MCKI and S/N of LOUT/ROUT pins
AK4646
Table 15. BICK Output Frequency at Master Mode
1024fs
FS1 bit
MCKI
256fs
512fs
BCKO bit
MCKO
MCKI
BICK
LRCK
SDTO
SDTI
0
0
1
1
0
1
Figure 17. EXT Master Mode
(fs=8kHz, 20kHzLPF + A-weighted)
FS0 bit
256fs, 512fs or 1024fs
0
1
0
1
32fs or 64fs
BICK Output
Frequency
- 26 -
1fs
32fs
64fs
MCKI Input
83dB
93dB
93dB
Frequency
S/N
1024fs
256fs
256fs
512fs
MCLK
BCLK
LRCK
SDTI
SDTO
(default)
DSP or μP
Sampling Frequency
7.35kHz ∼ 48kHz
7.35kHz ∼ 13kHz
7.35kHz ∼ 48kHz
7.35kHz ∼ 26kHz
Range
(default)
[AK4646]
2007/05