ZL50060 ZARLINK [Zarlink Semiconductor Inc], ZL50060 Datasheet - Page 56

• Manufacturer Part Number: ZL50060
• Description: 16 K-Channel Digital Switch with High Jitter Tolerance, Per Stream Rate Conversion (2, 4, 8, 16, or 32 Mbps), and 64 Inputs and 64 Outputs
• Manufacturer: ZARLINK [Zarlink Semiconductor Inc]

14.0
This section describes the registers that are used in the device.
14.1
Address 0000
The Control Register defines which memory is to be accessed. It initiates the memory block programming mode
and selects the Backplane and Local data rate modes. The Control Register (CR) is configured as follows:
15:13
Bit
12
11
10
9
012D
A14-A0
014D
3FFF
Control Register (CR)
MODE[2:0]
Detailed Register Descriptions
H
MODE32L
Reserved
FBDEN
SMPL_
- 014C
MODE
Name
FBD_
H
H
H
.
H
Reset
Value
Backplane Output Bit Rate Register 0 - 31, BOBRR0 - 31
Memory BIST Register, MBISTR
Device Identification Register, DIR
0
0
0
0
0
Table 18 - Address Map for Registers (A14 = 0) (continued)
Frame Boundary Discriminator Mode
When set to 111
frequency and high frequency jitter.
When set to 000
frequency jitter only.
All other values are reserved.
These bits are ignored when FBDEN bit is LOW.
Sample Point Mode
When LOW the input bit sampling point is always at the 3/4 bit location. The input bit
fractional delay is programmed in 1/4 bit increments from 0 to 7 3/4 as per the value
of the LIDR0 to LIDR31 and BIDR0 to BIDR31 registers.
When HIGH, the input bit sampling point is programmed to the 3/4, 4/4, 1/4, 2/4 bit
location as per the value of the LIDR0 to LIDR31 and BIDR0 to BIDR31 registers. In
addition, the incoming data can be delayed by 0 to 7 bits in 1 bit increments.
See Table 24, Table 25, Table 28 and Table 29 for details.
Reserved
Must be set to 0 for normal operation
Frame Boundary Discriminator Enable
When LOW, the frame boundary discriminator function is disabled.
When HIGH, enables frame boundary discriminator function which allows the
device to tolerate inconsistent frame boundaries, hence improving the tolerance to
cycle-to-cycle variation on the input clock.
Local 32MHz Mode
When LOW, Local streams LSTi0-31 and LSTo0-31 can be individually programmed
for data rates of 2, 4, 8, or 16 Mbps.
When HIGH, Local streams LSTi0-15 and LSTo0-15 operate at 32.768 Mbps only
and LSTi16-31 and LSTo16-31 are unused.
Table 19 - Control Register Bits
B
B
Zarlink Semiconductor Inc.
, the Frame Boundary Discriminator can handle both low
, the Frame Boundary Discriminator is set to handle lower
ZL50060/1
56
Register
Description
Data Sheet