SED1565 EPSON [Epson Company], SED1565 Datasheet - Page 57

• Manufacturer Part Number: SED1565
• Description: Direct display of RAM data through the display data RAM
• Manufacturer: EPSON [Epson Company]

• Sleep Mode
This stops all operations in the LCD display system, and as long as there are no accesses from the MPU, the consumption
current is reduced to a value near the static current. The internal modes during sleep mode are as follows:
• Standby Mode
The duty LCD display system operations are halted and only the static drive system for the indicator continues to
operate, providing the minimum required consumption current for the static drive. The internal modes are in the
following states during standby mode.
When a reset command is performed while in standby mode, the system enters sleep mode.
* When an external power supply is used, it is recommended that the functions of the external power supply circuit
* When the master is turned on, the oscillator circuit is operable immediately after the powering on.
NOP
Non-OPeration Command
Test
This is a command for IC chip testing. Please do not use it. If the test command is used by accident, it can be cleared
by applying a “L” signal to the RES input by the reset command or by using an NOP.
Note: The SED1565 Series chips maintain their operating modes until something happens to change them. Consequently,
1
2
1
2
A0 RD WR D7 D6 D5 D4 D3 D2 D1 D0
A0 RD WR D7 D6 D5 D4 D3 D2 D1 D0
0
0
be stopped when the power saver mode is started. For example, when the various levels of liquid crystal drive voltage
are provided by external resistive voltage dividers, it is recommended that a circuit be added in order to cut the
electrical current flowing through the resistive voltage divider circuit when the power saver mode is in effect. The
SED1565 series chips have a liquid crystal display blanking control terminal DOF. This terminal enters an “L” state
when the power saver mode is launched. Using the output of DOF, it is possible to stop the function of an external
power supply circuit.
The oscillator circuit and the LCD power supply circuit are halted.
All liquid crystal drive circuits are halted, and the segment in common drive outputs output a V
The LCD power supply circuits are halted. The oscillator circuit continues to operate.
The duty drive system liquid crystal drive circuits are halted and the segment and common driver outputs output
a V
E R/W
E R/W
1
1
excessive external noise, etc., can change the internal modes of the SED1565 Series chip. Thus in the packaging
and system design it is necessary to suppress the noise or take measure to prevent the noise from influencing
the chip. Moreover, it is recommended that the operating modes be refreshed periodically to prevent the effects
of unanticipated noise.
DD
level. The static drive system does not operate.
0
0
1
1
1
1
1
1
0
1
0
*
* Inactive bit
0
*
1
*
1
*
EPSON
SED1565 Series
DD
level.
8–55