MSP3435G ETC [List of Unclassifed Manufacturers], MSP3435G Datasheet - Page 91

• Manufacturer Part Number: MSP3435G
• Description: MSP 34x5G Multistandard Sound Processor Family
• Manufacturer: ETC [List of Unclassifed Manufacturers]

PRELIMINARY DATA SHEET
6.7. Demodulator Source Channels in Manual Mode
6.7.1. Terrestric Sound Standards
Table 6–17 shows the source channel assignment of
the demodulated signals in case of manual mode for
all terrestric sound standards. See Table 2–2 for the
assignment in the Automatic Sound Select mode. In
manual mode for terrestric sound standards, only two
demodulator sources are defined.
6.7.2. SAT Sound Standards
Table 6–18 shows the source channel assignment of
the demodulated signals for SAT sound standards.
Micronas
6.8. Exclusions of Audio Baseband Features
In general, all functions can be switched independently.
Two exceptions exist:
1. NICAM cannot be processed simultaneously with
2. FM adaptive deemphasis cannot be processed
6.9. Compatibility Restrictions to MSP 34x5D
The MSP 34x5G is fully hardware compatible to the
MSP 34x5D. However, to substitute a MSP 34x5D by
the corresponding MSP 34x5G, the controller software
has to be adapted slightly:
1. The register FM-Matrix (00 0E
2. With the MSP 34x5G, the STANDARD SELECTION
the FM2 channel.
simultaneously with FM-identification.
changed from “no matrix (00
(03
standards (see also Table 6–17).
initializes the FM-deemphasis, which is not the case
for the MSP 34x5D. So, if STANDARD SELECTION
is applied, this I
hex
)” during mono transmission of all TV-sound
2
C instruction can be omitted.
hex
MSP 34x5G
hex
)” to “sound A mono
low part) must be
91