ADIS16480 AD [Analog Devices], ADIS16480 Datasheet - Page 39

• Manufacturer Part Number: ADIS16480
• Description: Ten Degrees of Freedom Inertial Sensor
• Manufacturer: AD [Analog Devices]

Data Sheet
APPLICATIONS INFORMATION
PROTOTYPE INTERFACE BOARD
The
one interface printed circuit board (PCB), and four M2 × 0.4 ×
18 mm machine screws. The interface PCB provides four
holes for
for attaching the interface PCB to another surface. The
ADIS16480AMLZ
0.4 mm machine screws and the four larger holes, located in
each corner, support attachment with M2.5 or #4 machine
screws. J1 is a dual row, 2 mm (pitch) connector that works with
a number of ribbon cable systems, including 3M Part Number
152212-0100-GB (ribbon crimp connector) and 3M Part Number
3625/12 (ribbon cable). Note that J1 has 16 pads but currently
uses a 12-pin connector. The extra pins accommodate future
evaluation system plans.
Figure 28 provides the pin assignments for J1. The pin
descriptions match those listed in Table 5. The C1 and C2
locations provide solder pads for extra capacitors, which
can provide additional filtering for start-up transients and
supply noise.
ADIS16480/PCBZ
ADIS16480AMLZ
Figure 27. Physical Diagram for the
Figure 28.
attachment holes are pre-tapped for M2 ×
DIO1
DIO3
GND
GND
DNC
VDD
RST
CS
6.35mm
ADIS16480/PCBZ
includes one ADIS16480AMLZ,
11
13
15
1
3
5
7
9
58.42mm
attachment and four larger holes
64.77mm
J1
MOUNTING
ADIS16480
10
12
14
16
2
4
6
8
HOLES
J1 Pin Assignments
SCLK
DOUT
DIN
GND
VDD
VDD
DIO2
DIO4
ADIS16480/PCBZ
1.65mm
11.30mm
Rev. 0 | Page 39 of 40
INSTALLATION TIPS
Figure 29 and Figure 30 provide the mechanical design
information used for the ADIS16480/PCBZ. Use these
figures when implementing a connector-down approach,
where the mating connector and the
the same surface. When designing a connector-up system, use
the mounting holes shown in Figure 29 as a guide in designing
the bulkhead mounting system and use Figure 30 as a guide in
developing the mating connector interface on a flexible circuit
or other connector system. The suggested torque setting for the
attachment hardware is 40 inch-ounces, or 0.2825 N-m.
NOTES
1. ALL DIMENSIONS IN mm UNITS.
0.054 [1.37]
Figure 30. Suggested Layout and Mechanical Design for the Mating Connector
0.022±
NONPLATED
THRU HOLE 2×
0.019685
[0.5000]
(TYP)
Figure 29. Suggested Mounting Hole Locations, Connector Down
DIA (TYP)
19.800 BSC
5 BSC
0.022 DIA THRU HOLE (TYP)
NONPLATED THRU HOLE
39.600 BSC
0.4334 [11.0]
5 BSC
ADIS16480AMLZ
FOR MATING SOCKET
0.0394 [1.00]
ALIGNMENT HOLES
0.0240 [0.610]
ADIS16480
0.560 BSC 2×
0.0394 [1.00]
2.500 BSC 4×
are on
0.1800
[4.57]