AT49BV322D-70CUSL383 Atmel, AT49BV322D-70CUSL383 Datasheet - Page 2

• Manufacturer Part Number: AT49BV322D-70CUSL383
• Description: Flash, Semiconductors and Actives, ic, flash, Memory
• Manufacturer: Atmel

The VPP pin provides data protection. When the V
input is below 0.4V, the program and erase
PP
functions are inhibited. When V
is at 1.65V or above, normal program and erase operations
PP
can be performed. With V
at 10.0V, the program (Dual-word Program command) operation is
PP
accelerated.
A six-byte command (Enter Single Pulse Program Mode) sequence to remove the requirement
of entering the three-byte program sequence is offered to further improve programming time.
After entering the six-byte code, only single pulses on the write control lines are required for writ-
ing into the device. This mode (Single Pulse Byte/Word Program) is exited by powering down
the device, or by pulsing the RESET pin low for a minimum of 500 ns and then bringing it back to
V
. Erase, Erase Suspend/Resume and Program Suspend/Resume commands will not work
CC
while in this mode; if entered they will result in data being programmed into the device. It is not
recommended that the six-byte code reside in the software of the final product but only exist in
external programming code.
The BYTE pin controls whether the device data I/O pins operate in the byte or word configura-
tion. If the BYTE pin is set at logic “1”, the device is in word configuration, I/O0 - I/O15 are active
and controlled by CE and OE.
If the BYTE pin is set at logic “0”, the device is in byte configuration, and only data I/O pins I/O0
- I/O7 are active and controlled by CE and OE. The data I/O pins I/O8 - I/O14 are tri-stated, and
the I/O15 pin is used as an input for the LSB (A-1) address function.
AT49BV322D(T)
2
3582B–FLASH–11/05