853S9252BKILF IDT, 853S9252BKILF Datasheet - Page 5

• Manufacturer Part Number: 853S9252BKILF
• Description: Clock Drivers & Distribution
• Manufacturer: IDT

Specifications of 853S9252BKILF

• Product Category: Clock Drivers & Distribution
• Rohs: yes
• Part # Aliases: ICS853S9252BKILF

ICS853S9252I Data Sheet
Additive Phase Jitter
The spectral purity in a band at a specific offset from the fundamental
compared to the power of the fundamental is called the dBc Phase
Noise. This value is normally expressed using a Phase noise plot
and is most often the specified plot in many applications. Phase noise
is defined as the ratio of the noise power present in a 1Hz band at a
specified offset from the fundamental frequency to the power value of
the fundamental. This ratio is expressed in decibels (dBm) or a ratio
As with most timing specifications, phase noise measurements has
issues relating to the limitations of the equipment. Often the noise
floor of the equipment is higher than the noise floor of the device. This
is illustrated above. The device meets the noise floor of what is
shown, but can actually be lower. The phase noise is dependent on
the input source and measurement equipment.
ICS853S9252BKI REVISION A JULY 29, 2011
Offset from Carrier Frequency (Hz)
5
of the power in the 1Hz band to the power in the fundamental. When
the required offset is specified, the phase noise is called a dBc value,
which simply means dBm at a specified offset from the fundamental.
By investigating jitter in the frequency domain, we get a better
understanding of its effects on the desired application over the entire
time record of the signal. It is mathematically possible to calculate an
expected bit error rate given a phase noise plot.
The source generator used is, low noise Wenzel Oscillator at
122.88MHz.
Additive Phase Jitter @ 122.88MHz
2.5V, 3.3V ECL/LVPECL CLOCK/DATA FANOUT BUFFER
10Hz to 10MHz = 45fs (typical)
©2011 Integrated Device Technology, Inc.