FT221XS-R FTDI, FT221XS-R Datasheet - Page 27
![no-image](/images/no-image-200.jpg)
FT221XS-R
Manufacturer Part Number
FT221XS-R
Description
USB Interface IC USB to 8 bit SPI / FT1248 IC SSOP-20
Manufacturer
FTDI
Datasheet
1.FT221XS-R.pdf
(47 pages)
Specifications of FT221XS-R
Rohs
yes
Product
USB 2.0
Data Rate
12 Mbps, 480 Mbps
Interface Type
USB
Operating Supply Voltage
2.97 V to 5.5 V
Operating Supply Current
8.1 mA to 13.1 mA
Maximum Operating Temperature
+ 85 C
Mounting Style
SMD/SMT
Package / Case
SSOP-20
Tradename
X-Chip
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
FT221XS-R
Manufacturer:
FTDI
Quantity:
780
7.2 Self Powered Configuration
Figure 7.2 Self Powered Configuration
Figure 7.2 illustrates the FT221X in a typical USB self powered configuration. A USB self powered device
gets its power from its own power supply, VCC, and does not draw current from the USB bus. The basic
rules for USB self powered devices are as follows –
The power descriptor in the internal MTP memory of the FT221X should be programmed to a value of
zero (self powered).
In order to comply with the first requirement above, the USB bus power (pin 1) is used to control the
VBUS_Sense pin of the FT221X device. When the USB host or hub is powered up an internal 1.5kΩ
resistor on USBDP is pulled up to +3.3V, thus identifying the device as a full speed device to the USB
host or hub. When the USB host or hub is powered off, VBUS_Sense pin will be low and the FT221X is
held in a suspend state. In this state the internal 1.5kΩ resistor is not pulled up to any power supply
(hub or host is powered down), so no current flows down USBDP via the 1.5kΩ pull-up resistor. Failure to
do this may cause some USB host or hub controllers to power up erratically.
Figure 7.2 illustrates a self powered design which has a +3.3V to +5.25V supply.
Note:
i)
ii)
iii)
1. When the FT221X is in reset, the UART interface I/O pins are tri-stated. Input pins have internal
100nF
200kΩ pull-up resistors to VCCIO, so they will gently pull high unless driven by some external
logic.
SHIELD
A self powered device should not force current down the USB bus when the USB host or hub
controller is powered down.
A self powered device can use as much current as it needs during normal operation and USB
suspend as it has its own power supply.
A self powered device can be used with any USB host, a bus powered USB hub or a self
powered USB hub.
5
100nF
Copyright © 2013 Future Technology Devices International Limited
GND
1
2
3
4
VCC
+
GND
4k7
4.7uF
GND
10k
47pF
GND
VCC(3.3-5.25V)
47pF
Document No.: FT_000630 Clearance No.: FTDI# 263
GND
27R
27R
100nF
USBDM
USBDP
VCC
VBUS_SENSE
3V3OUT
VCCIO
RESET#
FT221X
Version 1.2
27