MAX9502GEVKIT+ Maxim Integrated, MAX9502GEVKIT+ Datasheet - Page 2

• Manufacturer Part Number: MAX9502GEVKIT+
• Description: Video Amplifiers Evaluation Kit for the MAX9502G/MAX9502M
• Manufacturer: Maxim Integrated

Specifications of MAX9502GEVKIT+

• Supply Current: 5.3 mA
• Maximum Power Dissipation: 168 mW
• Snr: 68 dB
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2.5 V

Figure 1. 100 IRE Multiburst Signal—Sync Tip at Ground
•
•
•
•
The MAX9502G dual-package EV kit is fully assembled
and tested. Follow these steps to verify board opera-
tion. Do not turn on the power supply until all con-
nections are completed.
1) To test U1 (µDFN package), place a shunt across
MAX9502G Dual-Package Evaluation Kit
2
2.5V to 3.6V, 500mA DC power supply for VCC
Video signal generator (CVBS)
Video measurement equipment
(e.g., Tektronix VM700T)
Two BNC/BNC 75Ω cables
pins 1-2 of jumper JU2, pins 1-2 of jumper JU1, and
_______________________________________________________________________________________
Recommended Equipment
Quick Start
2) Connect the output of the video signal generator to
pins 1-2 of jumper JU4. To test U2 (SC70 package),
place a shunt across pins 1-2 of jumper JU3, pins
2-3 of jumper JU1, and pins 2-3 of jumper JU4. JU2
sets the SHDN pin high to enable the µDFN part,
and JU3 sets the SHDN pin high to enable the
SC70 part. JU1 applies the input signal to the
respective part, and JU4 selects the respective out-
put signal (see Tables 1 and 2).
the BNC IN connector (J1) using one of the BNC
cables. Note the video signal generator should be
biased so that the sync tip is at ground, not below
ground.