SAP51C-B-G1-R ZMDI, SAP51C-B-G1-R Datasheet - Page 10

• Manufacturer Part Number: SAP51C-B-G1-R
• Description: Interface - Specialized ASI
• Manufacturer: ZMDI

Specifications of SAP51C-B-G1-R

• Rohs: yes
• Product Type: Actuator Sensor Interface IC
• Operating Supply Voltage: 16 V to 34 V
• Supply Current: 6 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOP-16
• Minimum Operating Temperature: - 25 C

1.2. Operating Conditions
Table 2: Operating Conditions
Symbol
V
V
I
I
I

1
2
3
Table 3: Crystal Frequency
Symbol
f
4
1.3. EMC Behavior
The IC has to fulfill the requirements defined in AS-Interface Complete Specification V2.11 [1] and related test
requirements AS-Interface Slave ICs.
In addition to the AS-Interface Complete Specification and in combination with a reference component circuit
the IC has to achieve a communication failure rate less than 10% of the allowed failure rate according to the
"Fast Transient" test method specified in the related AS-Interface association test procedures.
The above specified behavior is correct by design and has to be proven while IC characterization.
1.4. Quality Standards
The quality of the IC will be ensured according to the ZMDI quality standards. ZMDI is a qualified supplier
according to ISO/TS 16949:2002 and ISO 14001:1996.
The following reference documents apply for the development process:
Functional device parameters are valid for device operating conditions specified in chapter 1.2 at page 8.
Production device tests are performed within the recommended ranges of V
(+85°C and -25°C on sample base only) unless otherwise stated.
Data Sheet
October 20, 2011
LTGP
CL1
CL2
c
amb
Below V
UOUT and U5R.
Outside of these limits the send current shape and send current amplitude cannot be guaranteed.
f
the internal clock circuit accordingly.
LTGN
LTGP
The IC automatically detects whether the crystal frequency is 5.333MHz or 16.000MHz and controls
c
SAP5S / SAP51
Universal Actuator-Sensor Interface IC
= 16.000 MHz, no load at any pin, transmitter turned off, digital state machine is in idle state


MANAGEMENT REGULATION: 0410 PRODUCT DEVELOPMENT PROCEDURE
PROCESS SPECIFICATION: ZMDI C7D 0.6µM TECHNOLOGY
LTGPmin
Parameter
Negative supply voltage
DC voltage at LTGP relating to V
Operating current at V
Max. output sink current at pins D3...D0, DSTBn
Max. output sink current at pins P0...P3, PSTBnBn
Ambient temperature range, operating range
Parameter
Crystal frequency
the power supply block may not be able to provide the specified output currents at
© 2011 Zentrum Mikroelektronik Dresden AG — Rev. 3.0
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without
the prior written consent of the copyright owner. The information furnished in this publication is PRELIMINARY and subject to
changes without notice.
UIN
= 30V
LTGN
Min
0
16
-25
Nom.
5.333/16.000 MHz
Max.
0
34
6
10
10
85
LTGP
- V
Unit
V
V
mA
mA
mA
°C
LTGN
Unit
, amb = +25°C
1, 2
3
Note
22 of 64
Note
4