Z4A2321 Memtech, Z4A2321 Datasheet - Page 66

• Manufacturer Part Number: Z4A2321
• Description: Solid State Drives - SSD 32GB DRIVE IND TEMP
• Manufacturer: Memtech

Specifications of Z4A2321

• Product Category: Solid State Drives - SSD
• Product: SATA Flash Drives
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C

50
Drive Configuration
The drive must be configured to operate as either the Primary (Device 0) or Secondary (Device 1)
IDE device. The Primary/Secondary setting represents the order of electronic devices on an IDE
channel. If the Zeus SSD is the only ATA (IDE) drive installed in the system, the drive is configured
as the primary device. If two drives are installed in the machine, one device must be configured as
the primary and the remaining device as the secondary. Jumper pins located at the rear of the Zeus
SSD allow you to configure the drive as either the primary or the secondary device.
Jumper Pins
Zeus SSDs conforming to the 2.5-inch form factor use a 44-pin ATA bus/DC power combination
connector. To configure the SSD as either the Primary or Secondary device, place a jumper across
the appropriate pins (A - D) as illustrated in Figure 6.
Figure 6. Primary/Secondary Setting for 2.5-inch Zeus ATA SSDs
If the host system has multiple drives, it may be necessary to
configure disk storage using a Primary/Secondary (Device 0/
Device 1) setup. To accomplish this, boot the computer using
IDE HDD Auto Detection available in the CMOS Setup.
Zeus 2.5-Inch ATA Solid State Drive