M28W160ECT70ZB6E NUMONYX, M28W160ECT70ZB6E Datasheet - Page 19

• Manufacturer Part Number: M28W160ECT70ZB6E
• Description: IC FLASH 16MBIT 70NS 46TFBGA
• Manufacturer: NUMONYX

Specifications of M28W160ECT70ZB6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 16M (1M x 16)
• Speed: 70ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 46-TFBGA
• Cell Type: NOR
• Density: 16Mb
• Access Time (max): 70ns
• Interface Type: Parallel
• Boot Type: Top
• Address Bus: 20b
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: -40C to 85C
• Package Type: TFBGA
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 16b
• Number Of Words: 1M
• Supply Current: 18mA
• Mounting: Surface Mount
• Pin Count: 46
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

gram/Erase Controller Status bit is High (Program/
Erase Controller inactive). Bit 2 is set within 5µs of
the Program/Erase Suspend command being is-
sued therefore the memory may still complete the
operation rather than entering the Suspend mode.
When a Program/Erase Resume command is is-
sued the Program Suspend Status bit returns Low.
Block Protection Status (Bit 1). The Block Pro-
tection Status bit can be used to identify if a Pro-
gram or Erase operation has tried to modify the
contents of a locked block.
Table 10. Status Register Bits
Note: Logic level '1' is High, '0' is Low.
Bit
7
6
5
4
3
2
1
0
P/E.C. Status
Erase Suspend Status
Erase Status
Program Status
V
Program Suspend Status
Block Protection Status
Reserved
PP
Status
Name
Logic Level
'1'
'0'
'1'
'0'
'1'
'0'
'1'
'0'
'1'
'0'
'1'
'0'
'1'
'0'
When the Block Protection Status bit is High (set
to ‘1’), a Program or Erase operation has been at-
tempted on a locked block.
Once set High, the Block Protection Status bit can
only be reset Low by a Clear Status Register com-
mand or a hardware reset. If set High it should be
reset before a new command is issued, otherwise
the
Reserved (Bit 0). Bit 0 of the Status Register is
reserved. Its value must be masked.
Note: Refer to
Pseudo Codes, for using the Status Register.
new
Ready
Busy
Suspended
In progress or Completed
Erase Error
Erase Success
Program Error
Program Success
V
V
Suspended
In Progress or Completed
Program/Erase on protected Block, Abort
No operation to protected blocks
PP
PP
command
M28W160ECT, M28W160ECB
Invalid, Abort
OK
APPENDIX
Definition
will
C., Flowcharts and
appear
to
19/50
fail.