AT88SC153-10SU-00 Atmel, AT88SC153-10SU-00 Datasheet - Page 13

• Manufacturer Part Number: AT88SC153-10SU-00
• Description: IC EEPROM 2KBIT 1MHZ 8SOIC
• Manufacturer: Atmel
• Series: CryptoMemory®r

Specifications of AT88SC153-10SU-00

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 2K (256 x 8)
• Speed: 1MHz
• Interface: Serial
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9.6
1016E–SMEM–12/07
Verify Password
Figure 9-5.
Figure 9-6.
Note:
This command must be transmitted twice in sequence to successfully verify a write or read pass-
word. The first Verify Password command can be considered an initialization command. It will
write a new bit (“0”) in the PAC corresponding to the “r” and “p” bits. The data bits in this initial-
ization command are ignored. The second Verify Password command will compare the 3-byte
password data presented with the corresponding password value stored in memory. If the com-
parison is valid, the PAC will be cleared. For both commands, once the command sequence is
completed and a stop condition is issued, a nonvolatile write cycle is initiated to update the asso-
ciated attempts counter. After the stop condition is issued, an ACK polling sequence with the
specific command byte of $BD will indicate the end of the write cycle and will read the attempts
counter in the configuration zone. The initialization command will result in a “0” bit in the PAC.
The second Verify Password command will read $FF in the PAC if the verification was
successful.
Pw: Password, 3 bytes.
The two bits “rp” indicate the password to compare:
r = 0: Write password
r = 1: Read password
p: Password set number
rp = 01 for the secure code
Answer-to-reset Values
Verify Password
$2C
$AA
$55
$A1
13