EV-ADF4002SD1Z Analog Devices, EV-ADF4002SD1Z Datasheet - Page 5

• Manufacturer Part Number: EV-ADF4002SD1Z
• Description: Clock & Timer Development Tools PLL EB (No filter or VCO)
• Manufacturer: Analog Devices
• Type: PLL Synthesizers / Multipliers / Dividersr

Specifications of EV-ADF4002SD1Z

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: ADF4002
• Frequency: 400 MHz
• Operating Supply Voltage: 6 V to 12 V
• Interface Type: USB
• Operating Supply Current: 5 mA
• Factory Pack Quantity: 1
• For Use With: EVAL-SDP-CS1Z

Evaluation Board User Guide
DEFAULT OPERATION AND JUMPER SELECTION
SETTINGS
This board is shipped without a TCXO, low-pass filter, or a
VCO. Users must insert suitable components to complete a PLL.
Link positions are outlined in Table 1.
Table 1. Link Positions and Function
Link
LK1
LK2
LK3 (V
LK4 (V
LK5 (V
DD
VCO
P
)
)
)
Position
A
B
A
B
A
B
A
B
A
B
Options
R1A
RSET
GND
VDD
5V
3V
5V
3V
5V
3V
Description
Not used
Normal operation
Hardware power-down
Normal operation
Not used
Normal operation
VCO supply 5 V
VCO supply 3 V
V
V
P
P
supply 5 V
supply 3 V
Rev. A | Page 5 of 24
SYSTEM DEMONSTRATION PLATFORM (SDP)
The system demonstration platform (SDP) is a series of control-
ler boards, interposer boards, and daughter boards that can be
used for easy low cost evaluation of Analog Devices, Inc.,
components and reference circuits. It is a reusable platform
whereby a single controller board can be reused in various
daughter board evaluation systems.
Controller boards connect to the PC via USB 2.0 and provide a
range of communication interfaces on a 120-pin connector.
The pinout for this connector is strictly defined. This 120-pin
connector’s receptacle is on all SDP daughter boards, compo-
nent evaluation boards, and Circuits from the Lab™ reference
circuit boards. There are two controller boards in the platform:
the SDP-B, which is based on the Blackfin® ADSP-BF527, and
the SDP-S, which is a serial interface only controller board.
The SDP-S has a subset of the SDP-B functionality.
Interposer boards route signals between the SDP 120-pin con-
nector and a second connector. When the second connector is
also a 120-pin connector, the interposer can be used for signal
monitoring of the 120-pin connector signals. Alternatively, the
second connector allows SDP platform elements to be integrated
into a second platform, for example, the BeMicro SDK. More
information on the SDP can be found at www.analog.com/sdp.
UG-108