EV-ADF4153SD1Z Analog Devices, EV-ADF4153SD1Z Datasheet - Page 12

• Manufacturer Part Number: EV-ADF4153SD1Z
• Description: Clock & Timer Development Tools Evaluation Board I.C.
• Manufacturer: Analog Devices
• Type: PLL Synthesizers / Multipliers / Dividersr

Specifications of EV-ADF4153SD1Z

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: ADF4153
• Frequency: 4 GHz
• Operating Supply Voltage: 6 V to 12 V
• Operating Supply Current: 20 mA
• Factory Pack Quantity: 1
• For Use With: EVAL-SDP-CS1Z

UG-167
EVALUATION AND TEST
To evaluate and test the performance of the ADF4153, use the
following procedure:
1.
2.
3.
4.
5.
6.
7.
Install the SDP-S software drivers and ADF4153-4-6-7
software. Connect the evaluation board to a PC using the
supplied USB cable. Follow the hardware driver installation
procedure that appears.
Connect the SDP-S connector to the EV-ADF4153SD1Z.
Connect a spectrum analyzer to Connector J2.
Run the ADF4153-4-6-7 software.
Select the SDP board and the
Device and Connection tab of the software front panel
window.
In the software window, set the VCO center frequency
(Figure 19 shows a screenshot of the signal source analyzer
operating in phase noise mode, taken at a carrier frequency
of 1750 MHz). Set the proper PFD frequency to 25 MHz,
and program the reference frequency to equal 25 MHz.
The charge pump current should equal 2.5 mA. See
Figure 20 for the suggested setup.
Measure the output spectrum. Figure 19 shows a
1750 MHz output.
SUPPLIES
POWER
PC
ADF4153
device in the Select
EXTERNAL DC
EXTERNAL DC
SUPPLY
GND
EXTERNAL
POWER
SWITCH
Figure 20. Typical Evaluation Setup
POWER
LED
PLL
Rev. A | Page 12 of 24
LOCK DETECT LED
FILTER
LOOP
SDP-S BOARD
VCO
SDP CONNECTOR
PLL
Figure 19. Signal Source Analyzer Display
Evaluation Board User Guide
TCXO
REFERENCE IN/
REFERENCE OUT
GENERATOR
SPECTRUM
ANALYZER
SIGNAL