W5100E01-AVR WIZnet, W5100E01-AVR Datasheet - Page 28

• Manufacturer Part Number: W5100E01-AVR
• Description: Development Boards & Kits - AVR W5100 EVAL BOARD BASED ON AVR
• Manufacturer: WIZnet

Specifications of W5100E01-AVR

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: ATMEGA128
• Core: AVR8
• Interface Type: LAN, RS-232
• Operating Supply Voltage: 5 V
• Data Bus Width: 8 bit

2.5. Troubleshooting Guide
2.5.1.
When you can not reach EVB B/D by Ping command,
2.5.2.
When the serial terminal screen remains blank with the power on after a connection is made
Step 1. Check if you connect correctly test PC and EVB B/D with UTP cable.
Step 2. Check if interface jumper of JP3 is correctly set.
Step 3. Check if you correctly change your test PC's network environment (IP address, Gateway,
Step 4. Check if link LED of MAGJACK(left LED from rear view) is on? If it is off, check UTP cable is
working properly.
Step 1. Check the connection condition of the serial cable.
Step 2. Check the COM Port numbers of the PC and terminal coincide.
Step 3. Check the terminal’s baud rate 57600.
Ping
Subnet)? If not, you should change it as follows:
Misc.
JP3 : SPI mode (pin2-3 should be connected), Bus mode(pin1-2 should be connected)
- IP address: 192.168.0.3
- Gateway address: 192.168.0.1
- Subnet Mask: 255.255.255.0
© Copyright 2007 WIZnet Co., Inc. All rights reserved.
18