MIKROE-1205 mikroElektronika, MIKROE-1205 Datasheet - Page 10

• Manufacturer Part Number: MIKROE-1205
• Description: Development Boards & Kits - PIC / DSPIC EasyPIC FUSION v7 dsPIC33 PIC24 PIC32
• Manufacturer: mikroElektronika

Specifications of MIKROE-1205

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: PIC24x, dsPIC33x, PIC32MX4xx, PIC32MX7xx
• Interface Type: CAN, I2C, SPI
• Operating Supply Voltage: 7 V to 23 V
• Data Bus Width: 16 bit, 32 bit
• Dimensions: 266 mm x 220 mm
• For Use With: PIC24x, dsPIC33x, PIC32MX4xx, PIC32MX7xx

page 10
Figure 4-3: On-board MCU
socket has silkscreen
markings which will help
you to correctly orient the
MCU card before inserting.
How to properly place your MCU card into the socket?
Before you plug the microcontroller card into
the socket, make sure that the power supply is
turned off. Images below show how to correctly
plug the MCU card. First make sure that MCU card
orientation matches the silkscreen outline on the
1
EasyPIC Fusion
MCU card over the socket so each male header is
properly aligned with the female socket as shown
in Figure 4-4. Then put the MCU card slowly down
until all the pins match the socket. Check again if
Figure 4-4:
Place the
MCU card on
the socket
so that pins
are aligned
correctly.
2
™
v7 board MCU socket. Place the
everything is placed correctly and press the MCU
card until it is completely plugged into the socket
as shown in Figure 4-5. If done correctly all pins
should be fully inserted. Only now you can turn on
the power supply.
Figure 4-5 Properly
placed MCU card.
3
v7