EVB-PIC24 WIZnet, EVB-PIC24 Datasheet - Page 23

• Manufacturer Part Number: EVB-PIC24
• Description: Development Boards & Kits - PIC / DSPIC W3150A+EVAL BOARD BASED ON PIC24
• Manufacturer: WIZnet

Specifications of EVB-PIC24

• Rohs: yes
• Product: Development Kits
• Interface Type: RS-232
• Data Bus Width: 16 bit
• Dimensions: 50 mm x 40 mm

After the setup of EVB B/D is complete, run “AX1” at Test PC then try the connection to the IP Address.
When the connection between EVB B/D and “AX1” is successful, loop back the data. Refer to “AX1 Manual
Vx.x.pdf”
2.3.2.3.
Loopback TCP Client Application is an application that loop backs any file and packet data through TCP
channel connected with “AX1” Program of Test PC
After running the “AX1” on the server, set any channel of iinChip™ as “Loopback TCP Client” Application
type using [Manager>>Channel Config] menu of EVB B/D.
When setting up the “Loopback TCP Client” Application type of EVB B/D, set the Server IP as the IP Address
of the Test PC and set Server Port as the waiting Server Port Number(3000). Refer to
After setting up EVB B/D is complete, exit from the manager program and run EVB Test Application. If EVB
B/D is connected to “AX1” successfully, loop back the desired data. Refer to “AX1 Manual Vx.x.pdf”
2.3.2.4.
Loopback UDP Application is an application that loops back any File and Packet Data through UDP Channel
connected with “AX1” Program of Test PC. First of all, to test Loopback UDP, set up any Channel of iinChip™
as “Loopback UDP” Application Type using [Manager>>Channel Config] Menu of EVB B/D.
In setting up “Loopback UDP” Application type, set Source Port as any value. Here, it‟s set with 3000. Refer
to
Chapter 2.4.1.2
Loopback TCP Client
Loopback UDP
© Copyright 2006 WIZnet Co., Inc. All rights reserved.
<Fig 2.13: Loopback TCP Server Test>
<Fig 2.14: Loopback TCP Client>
Chapter
2.4.1.2.
13