LFE2M50E-PS-EVN Lattice, LFE2M50E-PS-EVN Datasheet - Page 20

• Manufacturer Part Number: LFE2M50E-PS-EVN
• Description: Programmable Logic IC Development Tools LatticeECP2M PCI Express Dev Kit
• Manufacturer: Lattice

Specifications of LFE2M50E-PS-EVN

• Rohs: yes
• Tool Is For Evaluation Of: LatticeECP2M-50
• Factory Pack Quantity: 1

PCIe Solutions Board Setup and Installation
LatticeECP2M PCI Express Development Kit User’s Guide
Figure 2: Interface Layout of the PCIe Solutions Board
Unpacking and Inspecting the Solutions Board
This section describes the proper steps to take to unpack the board to visually
inspect its layout. There is very little setup necessary for this kit.
To unpack and inspect the Lattice PCIe solutions board:
1. Remove the PCIe solutions board and accessories from its antistatic
2. Position the board to view the x1 mode side as shown in the Figure 2
3. Ensure that all configuration mode setting SW1 dip switches are pushed
4. Follow the procedures in the section, “Hardware Installation” which begin
packaging and compare the kit’s contents to the packaging list. Ensure
that you avoid situations that would create electrostatic discharge (ESD)
during setup or use of the board.
diagram and familiarize yourself with its basic layout and features. This
document uses the x1 mode in procedures. You can test in the x4 mode
but procedures will no longer apply in most cases.
down toward the board as shown in Figure 3, "Configuration Mode Setting
Dip Switches in “On” Position" on page 13.
on page 13. You must have a PC with a PCIe slot available to proceed.
The PCIe Solutions Board
12