MAX7315EVKIT+ Maxim Integrated, MAX7315EVKIT+ Datasheet - Page 7

• Manufacturer Part Number: MAX7315EVKIT+
• Description: Interface Development Tools Evaluation Kit for the MAX7315
• Manufacturer: Maxim Integrated
• Series: MAX7315r

Specifications of MAX7315EVKIT+

• Operating Supply Voltage: 2 V to 3.6 V

The shunt position of jumpers JU1, JU2, and JU5 deter-
mine the I
Refer to the MAX7315 IC data sheet for a detailed I
slave address map.
Jumpers JU3, JU4, JU6, JU8–JU13 set the port config-
urations as described in Table 3.
To use the MAX7315 EV kit with a user-supplied I
interface, install the shunt on jumper JU7 on pins 1 and
2. Connect SDA, SCL, and GND lines from the user-
supplied I
on the MAX7315 EV kit. Apply a 2.0V to 3.6V power
supply to the VCC pad of the MAX7315 EV kit.
Depending on the configuration of the user-supplied
I
pullup resistors R11 and R12.
2
C interface, it may be necessary to install the I
2
MAX7315 Evaluation Kit/Evaluation System
2
C interface to the SDA, SCL, and GND pads
C slave address of the MAX7315 EV kit.
_______________________________________________________________________________________
User-Supplied I
Reserved Jumper Settings
I
2
C Address Configuration
2
C Interface
2
2
2
C
C
C
Table 3. Port Configurations
*Default position.
JU8–JU13
JUMPER
JU3
JU4
JU6
POSITION
SHUNT
Open*
Open
Open
Open
1-2*
1-2*
1-2
1-2
2-3*
2-3*
P7 set as input port, controlled by
S1.
P7 set as output port, driving LED
D3.
Use P7 pad to evaluate this I/O pin.
P6 set as input port, controlled by
S2.
P6 set as output port, driving LED
D4.
Use P6 pad to evaluate this I/O pin.
INT/O8 set as GPO or interrupt,
driving LED D5.
Use INT/O8 pad to evaluate this I/O
pin.
When P0–P5 are set as output ports,
P0–P5 drive LED D1 and D2. When
P0–P5 are set as input ports, they
are pulled up by VLED.
Use P0–P5 pads to evaluate the
corresponding I/O pin.
DESCRIPTION
7