M45PE80-VMN6TP NUMONYX, M45PE80-VMN6TP Datasheet - Page 19

• Manufacturer Part Number: M45PE80-VMN6TP
• Description: IC FLASH 8MBIT 50MHZ 8SOIC
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M45PE80-VMN6TP

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 8M (1M x 8)
• Speed: 50MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Package: 8SOIC N
• Cell Type: NOR
• Density: 8 Mb
• Architecture: Sectored
• Block Organization: Symmetrical
• Typical Operating Supply Voltage: 3.3 V
• Sector Size: 64KByte x 16
• Timing Type: Synchronous
• Interface Type: Serial-SPI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: M45PE80-VMN6TPCT

6.3
Read Identification (RDID)
The Read Identification (RDID) instruction allows the device identification data to be read as
explained here, with the data values shown in
sequence.
Any Read Identification (RDID) instruction performed while an Erase or Program cycle is in
progress is not decoded, and has no effect on the cycle that is in progress.
The device is first selected by driving Chip Select (S) Low. Then, the 1-byte instruction code
for the instruction is shifted in.
After this the 20-bytes stored in memory are shifted out on Serial Data output (Q), including
the 3-bytes of manufacturer and device identification information, the 1-byte CFD length,
and the 16 bytes of CFD content. Each bit of these 20-bytes is shifted out during the falling
edge of Serial Clock (C). The instruction sequence is shown in
(RDID) instruction sequence and data-out
The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at
any time during data output. When Chip Select (S) is driven High, the device is put in the
Stand-by Power mode. Once in the Stand-by Power mode, the device waits to be selected,
so that it can receive, decode and execute instructions.
Table 4.
1. UID available on T9HX process technology parts.
Manufacturer
Identification
Manufacturer identification (1 byte): Numonyx value assigned by JEDEC.
Device identification (2 bytes): assigned by the device manufacturer.
–
–
Unique ID code (UID) (17 bytes): available upon customer request.
–
–
20h
The first byte indicates the memory type.
The second byte indicates the memory capacity of the device.
The first byte contains the length of the data that is contained in the UID.
The remaining 16 bytes are available upon customer request and contain the
optional Customized Factory Data (CFD) content. The CFD bytes are read-only
and can be programmed with customer data upon customer demand. If a
customer does not make a request, the device is shipped with all CFD bytes
programmed to zero (00h).
Read Identification (RDID) data-out sequence
Memory Type
40h
Device Identification
Memory Capacity
14h
sequence.
Table 4.: Read Identification (RDID) data-out
CFD length
10h
Figure 8: Read Identification
UID
(1)
CFD content
16 bytes
19/48