VND830SPTR-E STMicroelectronics, VND830SPTR-E Datasheet - Page 20

• Manufacturer Part Number: VND830SPTR-E
• Description: IC DRIVER HIGH SIDE 2CH PWRSO10
• Manufacturer: STMicroelectronics
• Type: High Sider

Specifications of VND830SPTR-E

• Input Type: Non-Inverting
• Number Of Outputs: 2
• On-state Resistance: 60 mOhm
• Current - Peak Output: 9A
• Voltage - Supply: 5.5 V ~ 36 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: PowerSO-10 Exposed Bottom Pad
• Switch Type: High Side
• Power Switch Family: VND830SP
• Power Switch On Resistance: 60mOhm
• Output Current: 9A
• Mounting: Surface Mount
• Supply Current: 12uA
• Package Type: PowerSO
• Operating Temperature (min): -40C
• Operating Temperature (max): 150C
• Operating Temperature Classification: Automotive
• Pin Count: 10
• Power Dissipation: 73500W
• Supply Voltage (min): 5.5 V
• Maximum Power Dissipation: 73500 mW
• Maximum Operating Temperature: + 150 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output / Channel: -
• Lead Free Status / Rohs Status: Compliant

VND830SP-E
3.4
Open-load detection in off-state
Off-state open load detection requires an external pull-up resistor (R
OUTPUT pin and a positive supply voltage (V
microprocessor.
The external resistor has to be selected according to the following requirements:
1.
2.
Because I
up resistor R
standby.
Figure 26. Open-load detection in off-state
no false open load indication when load is connected: in this case we have to avoid
V
V
no misdetection when load is disconnected: in this case the V
V
OUT
OUT
OLmax
S(OFF)
= (V
to be higher than V
; this results in the following condition R
PU
PU
should be connected to a supply that is switched OFF when the module is in
may significantly increase if V
/ (R
L
+ R
PU
))R
Olmin
Doc ID 10879 Rev 2
L
< V
; this results in the following condition
Olmin.
PU
out
) like the +5V line used to supply the
is pulled high (up to several mA), the pull-
PU
< (V
PU
- V
OLmax
OUT
Application schematic
PU
has to be higher than
) connected between
) / I
L(off2)
.
20/28