TLE6236G Infineon Technologies, TLE6236G Datasheet - Page 7

• Manufacturer Part Number: TLE6236G
• Description: IC SW SMART OCTAL LOWSIDE PDSO28
• Manufacturer: Infineon Technologies
• Type: Low Sider

Specifications of TLE6236G

• Input Type: SPI
• Number Of Outputs: 8
• On-state Resistance: 1.7 Ohm
• Current - Output / Channel: 250mA
• Current - Peak Output: 750mA
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: DSO-28
• Switch Type: Low Side
• Power Switch Family: TLE6236G
• Input Voltage: -0.3 to 7V
• Power Switch On Resistance: 1.7Ohm
• Output Current: 200mA
• Mounting: Surface Mount
• Supply Current: 1.5mA
• Package Type: DSO
• Operating Temperature (min): -40C
• Operating Temperature (max): 150C
• Operating Temperature Classification: Automotive
• Pin Count: 28
• Power Dissipation: 2W
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: SP000012767; TLE6236GNT; TLE6236GT; TLE6236GT

Functional Description
The TLE 6236 G is an octal-low-side power switch which provides a serial peripheral interface
(SPI) to control the 8 power DMOS switches, as well as diagnostic feedback. The power tran-
sistors are protected against short to V
by an active zener clamp.
The diagnostic logic recognizes a fault condition which can be read out via the serial diagnos-
tic output (SO).
Circuit Description
Output Stage Control
Each output is independently controlled by an output latch and a common reset line, which
disables all eight outputs. Serial data input (SI) is read on the falling edge of the serial clock. A
logic high input data bit turns the respective output channel ON, a logic low data bit turns it
OFF. CS must be low whilst shifting all the serial data into the device. A low-to-high transition
of CS transfers the serial data input bits to the output buffer.
Special conditions for Channel 1 to 4:
In addition to the serial control of the outputs it is possible to control channel 1 to channel 4
directly in parallel for PWM applications. These inputs are high active and ORed with the SPI
control bit. The parallel inputs are provided with internal pull down sources, to guarantee that
the channels are switched off when the inputs are not connected.
The table shows the OR-operation of the parallel inputs 1 ..4 and the corresponding SPI bits.
The outputs 5 .. 8 can be controlled in serial via SPI
Interface
Serial Control Bits (SI)
MSB
Serial Diagnostic Bits (SO)
MSB
V2.1
Ch. 8
DIAG7 DIAG6 DIAG5 DIAG4 DIAG3 DIAG2 DIAG1 DIAG0
7
7
Ch. 7
6
6
Ch. 6
5
5
Ch. 5
4
4
Ch. 4
BB
3
3
, overload, overtemperature and against overvoltage
Page
Ch. 3
2
2
7
IN 1 - 4
SPI-Bit 4 - 7 OUT 5 - 8
Ch. 2
D a t a s h e e t T L E 6 2 3 6 G
1
1
0
0
1
1
0
1
Ch. 1
SPI-Bit 0 - 3
LSB
LSB
0
0
OFF
0
1
0
1
ON
OUT 1 - 4
26.Aug. 2002
OFF
ON
ON
ON