TLE6230GP Infineon Technologies, TLE6230GP Datasheet - Page 10

• Manufacturer Part Number: TLE6230GP
• Description: IC SW SMART OCTAL LOWSIDE PDSO36
• Manufacturer: Infineon Technologies
• Type: Low Sider

Specifications of TLE6230GP

• Input Type: SPI
• Number Of Outputs: 8
• On-state Resistance: 800 mOhm
• Current - Peak Output: 1.5A
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: DSO-36
• Switch Type: Low Side
• Power Switch Family: TLE6230
• Input Voltage: -0.3 to 7V
• Power Switch On Resistance: 800mOhm
• Output Current: 1A
• Mounting: Surface Mount
• Supply Current: 1mA
• Package Type: DSO
• Operating Temperature (min): -40C
• Operating Temperature (max): 150C
• Operating Temperature Classification: Automotive
• Pin Count: 38
• Power Dissipation: 3300W
• Packages: PG-DSO-36
• Thermal Class: Heatslug down
• Id Nom: 8 x 0.5 A
• Channels: 8.0
• Comment: relay driver and general purpose
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output / Channel: -
• Lead Free Status / Rohs Status: Compliant
• Other names: SP000012169; SP000691114; TLE6230GP; TLE6230GPNT; TLE6230GPT; TLE6230GPT; TLE6230GPTR

A definite distinction between open load and short to ground is guaranteed by design.
The standard way of obtaining diagnostic information is as follows:
Clock in serial information into SI pin and wait approximately 150 µs to allow the outputs toset-
tle. Clock in the identical serial information once again - during this process the data coming
out at SO contains the bit combinations representing the diagnosis conditions as described in
figure 1.
By means of the control byte it is possible either to:
a) Serial Control of Outputs
Control byte is set to FFhex: Data byte will be accepted. The outputs will be switched ON or
OFF according to the information of the data byte and the parallel inputs (Channel 1 to 4 be-
cause of AND operation).
All other control words except the one for 'Diagnosis Only = 00hex' will also be accepted as a
valid control word and the data will be accepted.
Example: HLLHLHLH DDDDDDDD: Outputs will switch according to the data bits.
b) Diagnosis Only
Control byte is set to 00hex: Data byte will be ignored. Diagnostic information can be read out
at any time with no change of the switching conditions. Only 00hex means 'Diagnosis Only'.
V2.3
HHHHHHHH LHLHHLLL
LLLLLLLL XXXXXXXX
1
1 2
Control Byte
or b) purely get diagnostic information without changing the state of the outputs.
4 4
4 4
Control Byte
2
a) control the eight outputs according to the data byte, as well as being able to read the
4 4 1
44 1
diagnostic information
3
3
4 4
Data Byte
4 4
Data Byte
2
2
44
44
3
3
: Serial input information
: Serial input information
Page
10
Data Sheet TLE 6230 GP
18. Nov. 2009