TLE6244X Infineon Technologies, TLE6244X Datasheet - Page 2

• Manufacturer Part Number: TLE6244X
• Description: IC LOW SIDE SWITCH 18CHAN MQFM64
• Manufacturer: Infineon Technologies
• Type: Low Sider

Specifications of TLE6244X

• Input Type: SPI
• Number Of Outputs: 18
• On-state Resistance: 1 Ohm
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 64-BSQFM
• Packages: PG-MQFP-64
• Thermal Class: Heatslug down
• Id Nom: 2 x 3.0, 12 x 2.2, 4 x 1.1 A
• Pin Count: 64.0 Pins
• Channels: 18.0
• Comment: injectors, solenoids, relays, general purpose
• For Use With: DEMOBOARDTLE6244XIN - BOARD DEMO FOR TLE 6244X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output / Channel: -
• Current - Peak Output: -
• Other names: SP000013785; SP000304416; TLE6244; TLE6244; TLE6244XNT; TLE6244XT; TLE6244XXT

Final Data Sheet
OUT1, 2, 5, 6
OUT3, OUT4
OUT7, OUT8
OUT9, OUT10
OUT11...OUT14
OUT15, OUT16
OUT17, OUT18 *)
1. Description
1.1 Short Description
1.1.1 Features of the Power Stages
1.1.2 Diagnostic Features
1.1.3 VDD-Monitoring
1.1.4 µsec-bus
1.1.5 Power Stage OUT8
This circuit is available in MQFP64 package or as chip.
*) only serial control possible (via SPI)
Parallel connection of power stages is possible (see 1.13)
Internal short-circuit protection
Phase relation: non-inverting (exception: IN8->OUT8 is inverting)
The following types of error can be detected:
Individual detection for each output.
Serial transmission of the error code via SPI.
Low signal at pin ABE and shut-off of the power stages if VDD is out of the permitted range.
Exception: If OUT8 is controlled by IN8, OUT8 will only be switched off by the overvoltage
detection and not by undervoltage detection.
The state of VDD can be read out via SPI.
Alternatively to the parallel and SPI control of the power stages, a high speed serial bus inter-
face can be configured as control of the power stages OUT1...OUT7 and OUT9...OUT16.
OUT8 can be controlled by SPI or by the pin IN8 only. When controlled by IN8 this power stage
is functional if the voltage at the pin VDD is above 3,5V.
SPI mode the power stage is fully supervised by the VDD-monitor.
Short-circuit to U
Short-circuit to ground (SCG)
Open load (OL)
Overtemperature (OT)
Nominal Current R
2.2A
2.2A
1.1A
2.2A
2.2A
3.0A
1.1A
Batt
(SCB)
on,max
400m
380m
780m
380m
380m
280m
780m
at T
J
2
= 25°C static current limita-
OUT8 will not be reset by RST.
tion enabled by SPI
X
X
X
-
-
-
-
TLE 6244X
V4.2, 2003-08-29
Clamping
70V
70V
45V
45V
45V
45V
45V
In